User manual

7.2 Maintenance

Figure 28

Cleaning the sieve tube in the quick closure valve: Unscrew the hose connection from

the quick closure valve and remove from the quick closure valve with the sieve. Unscrew

the sieve tube from the hose connection and wash thoroughly with water. Mount in

reverse sequence after cleaning. Hand-tighten all screw connections.

CAUTION

You may be exposed to hazards that could injure you when cleaning the sieve tube.

Wear safety gloves and protective clothing, if necessary.



Completely depressurise the hose line by pulling the actuation lever on the quick

closure valve, even if the device is empty, and dispose of any remaining liquid in the

system onto vegetation.



The sealing ring in the container cap and all other moving parts must be regularly greased

with resin- and acid-free grease.



Only use original GLORIA spare parts for repairs.



Repairs must be carried out by a GLORIA service point.

NOTE!



To ensure optimal cleaning of the spraying device, the use of the GLORlA spraying

device cleaner, Art. No. 1100.0000 is recommended.

7.3 Storage

Figures 29 - 30

Empty and clean the device as described in the chapters Emptying and Maintenance.

Loosen the container cap – Clip spraying lance onto the spraying lance holder –

Store the device without pressure and frost-free.

CAUTION

You may be exposed to hazards that could injure you when handling the device and the

pesticides. You must therefore store the device and the pesticides away from children.

8 Problems with the device

8.1 Troubleshooting

Fault Cause Remedy

Device is leaking at the

screw connection

Hose loose

Tighten coupling nut and

carry out pressure test with

water

Spray pattern of nozzle not

Nozzle partially blocked Clean filter or nozzle

RZ_KRSG_EN.qxd:Text_EN 08.02.2013 16:05 Uhr Seite 24