operation manual

26
GB
!
Do not start or operate device if
bystanders are in the danger zone.
!
Never put your hands or feet near to
the rotating brushing equipment!
!
Never clean if others, in particular
children or animals, are in the area!
!
Never use the device in the rain.
You can regulate the speed of the
brush by pressing the speed control
on the adjustment wheel (R).
Hold the device securely by the
handle (A) and additional handle (E)
and switch on the device by pressing
and holding the ON/OFF safety
switch (D) in handle (A).
!
In case of work interruptions or
danger, release the ON/OFF safety
switch (D) immediately.
6.1.2 Assembly of the brushing
tools
Figures 12 - 20
CAUTION! RISK OF BURNS
CAUSED BY HOT PARTS!
During assembly or conversion work
the drive parts of the device or
components can still be very hot
and may cause burns.
It is therefore important to observe
the following safety instructions:
!
Wear protective gloves during
assembly!
Disassembly of surface brush followed by
assembly of the joint brush
!
Switch off the device and disconnect
the power cord (C) from the power
supply.
Open the locking device (K) of
the guide arm (M), as shown in the
illustration.
With the lock applied (K) remove the
guide arm (M) and then the surface
brush (N).
Now open the locking device (K)
of the drive arm (P), as shown in the
illustration and remove, with the lock
applied, (K) the drive arm (P) with
safety guard (O).
!
The surface brush is now successfully
dismantled.
Put the guiding wheel (I), as shown in
the illustration, on the steering side of
the motor/gear unit (L). Now slide the
lock (K) into open position , hold
this and press the guiding wheel (I)
further onto the coupling shaft up to
the stop.
Release the spring-loaded locking
device (K). The guiding wheel (I) is
locked when the locking device
independently returns to its original
position .
Put the pre-assembled joint brush
unit, as illustrated, on the drive side of
the motor/gear unit (L). Slide the lock
(K) into open position , hold this
and press the joint brush unit further
into the drive shaft up to the stop.
Release the spring-loaded locking
device (K), the joint brush unit is
10
11
12
13
14
15
16
Speed recommendations for
GLORIA brushes
Position 1-2 soft brushes (wood brush)
Position 3-4 harder brushes (stone brush)
Position 5-6 joint brush (wire brush)