Instructions / Assembly

Canopy
Existing & Required
Outlet Box
Finished Ceiling Line
Fixture Ground Wire
(Yellow/Green marking)
Fixture Wire
Black House Wire (HOT)
House Ground Wire (Green)
White House Wire (NEUTRAL)
Fixture
Wire
Adjustable
Round Plate
CAUTION RISK OF FIRE
MAX 50 WATTS,
TYPE Gu10 LAMP
O:5”
H:5/8”
O:5 5/8”
H:1/16”
Screw Ring
Round
Canopy
Round Plate
Min H:1 3/4”
®
Glow Lighting Inc.
Installation Instructions
For #598 1L SERIES
Fixture with less than 50LBS
WIRING AND INSTALLATION INSTRUCTIONS:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
( Manufacturer recommends a certified electrician should always be employed for the installation and wiring of the fixture )
Note to electrician:
1. All electrical connections must be in agreement with local codes, ordinances or the national electrical code. This product must be installed in accordance
with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
2. Turn off electricity at the main fuse box (or circuit breaker box) before beginning installation by switching circuit breaker off or removing fuse.
3. Do not connect this fixture to a non-grounded electrical system. (See wiring below) Warning: installing this fixture into a non-grounded electrical system could
allow metal parts of fixture to carry electrical current if any fixture wires, wire connections or splices become broken or loose. Under this condition, anyone
coming in contact with fixture is subject to electrical shock, which could cause injury of death.
4. Do Not suspend any fixture by the house wires. A fixture must always be mounted directly to an outlet box or to a cross bar which is first attached to outlet
box. Wire connections will not support the weight of a fixture. Suspending a fixture by the wires will result in the fixture falling, with the possibility of injury
and the danger of electrical shock or fire.
5. Be careful not to damage or cut the wire insulation (covering) during installation. Do not permit wires to contact any surface having a sharp edge. Doing so
may cause serious injury or death from electrical shock.
6. Do not use lamps (bulbs) having a wattage greater than the maximum value stated on the fixture. Doing so may cause the risk of fire.
7. If a dimmer control switch is used, obtain professional advice for the correct type and electrical rating required.
CAUTION: RISK OF ELECTRICAL SHOCK. Make sure the electrical supply to the chandelier is turned
off at the main fuse or circut breaker before doing any installation. Safety Information: Important! For your
protection and safety, carefully read and understand the information given on this sheet before beginning
installation. Failure to do so may lead to fire, electric shock, personal injury and property damage.
CUSTOMER COPY
12.11.15