Installation & Assembly

®
Glow Lighting Inc.
Installation Instructions
For #621-M SERIES
WIRING AND INSTALLATION INSTRUCTIONS:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED
( Manufacturer recommends
a certified electrician
should always be
employed for the
installation and wiring
of the fixture )
Note to electrician:
1. All electrical connections must be in agreement with local codes, ordinances or the national electrical code. This product must be installed in accordance with
the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
2. Turn off electricity at the main fuse box (or circuit breaker box) before beginning installation by switching circuit breaker off or removing fuse.
3. Do not connect this fixture to a non-grounded electrical system. (See wiring below) Warning: installing this fixture into a non-grounded electrical system could
allow metal parts of fixture to carry electrical current if any fixture wires, wire connections or splices become broken or loose. Under this condition, anyone
coming in contact with fixture is subject to electrical shock, which could cause injury of death.
4. Do Not suspend any fixture by the house wires. A fixture must always be mounted directly to an outlet box or to a cross bar which is first attached to outlet box.
Wire connections will not support the weight of a fixture. Suspending a fixture by the wires will result in the fixture falling, with the possibility of injury and the
danger of electrical shock or fire.
5. Be careful not to damage or cut the wire insulation (covering) during installation. Do not permit wires to contact any surface having a sharp edge. Doing so
may cause serious injury or death from electrical shock.
6. Do not use lamps (bulbs) having a wattage greater than the maximum value stated on the fixture. Doing so may cause the risk of fire.
7. If a dimmer control switch is used, obtain professional advice for the correct type and electrical rating required.
CAUTION: RISK OF ELECTRICAL SHOCK. Make sure the electrical supply to the chandelier is turned off at the main fuse or
circut breaker before doing any installation. Safety Information: Important! For your protection and safety, carefully read and
understand the information given on this sheet before beginning installation. Failure to do so may lead to fire, electric shock,
personal injury and property damage.
CUSTOMER COPY
09.11.15
Option#1
Option#2
Option#3
3 set of pipe:
-2pc x 6” Pipe
-2pc x 12” Pipe
-2pc x 18” Pipe
3/4/5/6 Light
Existing & Required
Outlet Box
Fixture Ground Wire
(Yellow/Green marking)
Black Fixture Wire
Black House Wire (HOT)
White House Wire (NEUTRAL)
White Fixture Wire
Cross
Bar/Plate
Machine Screw
Finished Ceiling Line
Canopy
A set of wire
A Round lock nut
House Ground Wire (Green)
Cover Plate
A Screw Ring