Owner manual

49
AEC-7763LC/LD & ARS-2022/2022D
Chapter 6 Troubleshooting
6.1 About LCD
After powering on if there is no LCD, please check if the connection of power cord is
frim and the environment of power outlet is normal.
6.2 About Error Messages
During Copy, Test, Compare and Verify, etc. if you press ESC to abort, an error
message will appear on LCD. Abortion may cause ARS-2022D to hang up, therefore
you have to power on again.
If reading fails, an error message will appear on LCD. Please get a new source
DVD to try again.
If ARS-2022D hasn’t detected any device after powering on, an error message will
appear on LCD.
If a DVD-ROM or DVD writer cannot read, please confirm the format of the source
DVD and check if it is damaged.
Use any DVD writer to read the source DVD. If it works, the DVD-ROM is probably
defective or not compatible with the source DVD.
Use a fine DVD writer as the data reader, and set the “Read Speed” at minimum.
6.3 About DVD-ROM/DVD Writer