Owner’s Manual

5-21
A. Hoist Assembly
B. Wheel Wrench
C. Jack
Handle Extensions
D. Hoist Shaft
E. Valve Stem,
Pointed Up
F. Spare Tire
G. Tire Retainer
H. Hoist Cable
I. Hoist Lock
J. Hoist Shaft
Access Hole
K. Hoist End of
Extension Tool
Follow these instructions to lower the spare tire:
1. If the vehicle is equipped with a hoist lock (I), open
the spare tire lock cover on the bumper and use the
ignition key to remove the lock.
2. Assemble the wheel wrench (B) and the two jack
handle extensions (C) as shown. Insert the hoist
end (K) (open end) of the extension through the
hole (J) in the rear bumper. Be sure the hoist end
of the extension connects into the hoist shaft (D)
(the ribbed square end of the extension is used to
lower the spare tire).
3. Turn the wheel wrench counterclockwise to lower
the spare tire (F) to the ground. Continue to turn the
wheel wrench until the spare tire can be pulled out
from under the vehicle. The wheel wrench has a
hook that allows you to pull the hoist cable (H)
towards you, to assist in reaching the spare tire.
4. When the tire has been lowered, tilt the retainer at
the end of the cable so it can be pulled up through
the wheel opening.
5. Put the spare tire near the flat tire.