Manual

If the wheel has a smooth center cap, place the

chisel end of the wheel wrench in the slot on

the wheel, and gently pry out.

If the wheel has bolt-on wheel covers, loosen the

plastic nut caps by turning the wheel wrench

in a counterclockwise direction. If needed, ﬁnish

loosening them by hand. The nut caps will not come

off. Using the ﬂat end of the wheel wrench, pry

along the edge of the cover until it comes off.

2. Use and turn the wheel wrench counterclockwise

to loosen the wheel nuts. Don’t remove the wheel

nuts yet.

Notice: If your vehicle has QUADRASTEER™ and

you use a jack to raise the vehicle without

positioning it correctly, you could damage the

QUADRASTEER™ system. When raising your

vehicle on a jack, avoid contact with tie rods and tie

rod boots.

5-98