Owner’s Manual

2. Tilt the tire toward the vehicle. Separate the
tire/wheel retainer (D) from the guide pin. Pull
the pin through the center of the wheel. Tilt the
retainer down through the center wheel opening.
Make sure the retainer is fully seated across
the underside of the wheel.
3. Assemble the two jack handle extensions (D) and
wheel wrench (E) as shown.
4. Insert the open end of
the extension (J)
through the hole in the
rear bumper (I) (hoist
shaft access hole).
5. Raise the tire part way upward. Make sure the
retainer is seated in the wheel opening.
5-105