Owner’s Manual

Black plate (8,1)
GMC Yukon/Yukon XL Owner Manual - 2011
5-8 Instruments and Controls
3. Press the set/reset button to
start the compass calibration.
Or, if the vehicle does not have
DIC buttons, press and hold the
trip odometer reset stem for
two seconds to start the
compass calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle
in tight circles at less than
8 km/h (5 mph) to complete
the calibration. The DIC
will display CALIBRATION
COMPLETE for a few seconds
when the calibration is complete.
The DIC display will then return
to the previous menu.
Clock
To set the time and date:
1. Turn the ignition key to ACC/
ACCESSORY or ON/RUN, then
press the
O button to turn the
radio on.
2. Press the
H button to display
HR, MIN, MM, DD, YYYY (hour,
minute, month, day, and year).
3. Press the softkey located under
any one of the tabs to change
that setting.
4. To increase the time or date, do
one of the following:
.
Press the softkey below the
selected tab.
.
Press the ¨ SEEK button.
.
Press the \ FWD button.
.
Turn the f knob clockwise.
5. To decrease the time or date, do
one of the following:
.
Press the © SEEK button.
.
Press the s REV button.
.
Turn the f knob
counterclockwise.
To change the time default setting
from 12 hour to 24 hour or to change
the date default setting from month/
day/year to day/month/year:
1. Press the
H button and then
the softkey located below the
forward arrow tab. 12H, 24H, the
date MM/DD (month and day),
and DD/MM/ (day and month)
displays.
2. Press the softkey located below
the desired option.
3. Press the
H button again to
apply the desired option, or let
the screen time out.