User Guide
In addition
to
the four stations already set,
up
to
three
more stations may be preset on each band by pressing
two adjoining buttons at the same time. Just:
1.
Tune in
the
desired station.
2.
Press SET. (SET will appear on the display.)
3.
Press
two
adjoining buttons at the same time, within
five seconds. Whenever you press the same two
buttons, the station
you
set
will return.
4.
Repeat the steps for each pair of pushbuttons.
P.SCAN:
Press both SEEK buttons
to
scan through
each of your preset stations.
The
system will scan
through and play each preset station stored on your
pushbuttons for a few seconds. Press either
SEEK
button or RECALL
to
stop scanning through the
preset stations.
Setting the Tone
BASS:
Slide this lever up or down to increase or
decrease bass.
TREB:
Slide this lever up or down
to
increase or
decrease treble. If a station is weak or noisy, you may
want to decrease the treble.
Adjusting
the Speakers
BAL:
Turn
the
control behind the upper knob
to
move
the sound
to
the left
or
right speakers. The middle
position balances the sound between the speakers.
FADE:
Turn the control behind the lower knob
to
move
the sound
to
the front or rear speakers. The middle
position balances the sound between the speakers.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30
to
45
minutes long
on
each side. Tapes longer than
that are
so
thin they may not work well in this player.
Once the tape is playing, use the knobs for VOLUME,
BAL
FADE,
BASS
and TREB just as
you
do
for
the
radio.
REV:
Press the SEEK left arrow
to
reverse
the
cassette tape. Press the SEEK right arrow
to
stop
reversing the tape.
FWD:
Press the SEEK right arrow to advance the
cassette tape. Press the SEEK left arrow to stop
forwarding the tape.
3-
12