User Guide

Use one Panasonic@ type CR2032 battery:
1. Insert a dime in the slot between the covers of the
transmitter housing near the key ring
hole. Remove
the bottom by twisting the dime.
2. Remove and replace the battery, positive side down.
r
3. Align the covers and snap them together.
4. Check the operation of the transmitter,
Synchronization
Synchronization may be necessary due to the security
method used by this system. The transmitter does
not
send the same signal twice to the receiver. The receiver
will not respond to
a signal it has been sent previously.
This prevents anyone from recording and playing back
the signal from the transmitter.
To resynchronize your transmitter, stand close
to your
vehicle and simultaneously press and hold the
LOCK
and UNLOCK buttons on the transmitter for at least
five seconds. The door locks should cycle
to confirm
synchronization.
If the locks do not cycle, see your
dealer for service.
2-8