User Guide
P.SCAN:
Press both SEEK buttons to scan through each
of the preset stations. The system will scan through and
play each preset station stored
on
your pushbuttons for a
few seconds. Press either SEEK button or RECALL to
stop scanning through
the
preset stations.
Setting
the
Tone
BASS:
Slide this lever up
to
increase the bass.
TREB:
Slide this lever up
to
increase the treble.
Slide the lever down
to
reduce noise with a weak
or noisy station.
Adjusting
the Speakers
BAL:
The control behind the VOLUME-BAL knob
balances the sound between the right and left speakers.
FADE:
The control behind the TUNE knob fades the
sound between the front and rear speakers.
Playing
a
Cassette
Tape
Your tape player is built
to
work best
with
tapes that
are
30
to
45
minutes long
on
each side. Tdpes longer than
that are
so
thin
they may
not
work
well
in
this player.
Once the tape is playing, use the knobs for VOLUME,
FADE
and BAL just as
you
do
for the radio.
FWD:
Press the
SEEK
right arrow
to
advance the
cassette tape. Press the SEEK left arrow to
stop
forwarding the tape.
REV:
Press
the
SEEK left arrow to reverse the
cassette tape. Press the SEEK right arrow to stop
reversing
the
tape.
RECALL:
Press this button
to
switch tape sides.
EJECT
Press this button to remove the tape or stop the
tape and play the radio.
CLN:
This message may appear on the display.
If
it
does, your cassette tape player needs
to
be cleaned.
It
will still play tapes, but you should clean
it
as soon as
possible
to
prevent damage to your tapes and player. See
“Care of Your Cassette Tdpe Player’’
in
the
Index. After
you
clean the player, press and hold
EJECT
for
five
seconds
to
reset the CLN indicator. The radio will
display
---
to show the indicator
was
reset.
3-10