User Guide

Front Turn Signal Lamps
(Sealed Beam Headlamps)
1. Remove the two screws
at the inside edge
of
the parkinghrn signal
lamp assembly.
2. Remove the lamp assembly by swinging it out from
the inside edge and sliding it out at the outside edge.
3. Squeeze the tab on the side of the lamp socket while
turning
the socket counterclockwise.
4. Pull the socket out of the
lamp assembly.
5. Push in gently on the bulb, turn it counterclockwise
and remove
it from the socket.
6. Put the new bulb in the socket, gently press in on the
bulb and turn
it to the right until it is tight.
7. Put the socket back into the lamp assembly and turn
it to the right until it locks.
8. Put the parking/tut-n signal lamp assembly back into
the vehicle and tighten the screws.
6-40