User's Manual

ManualsBrandsGmobi ManualsBattery ChargersApple Watch Magnetic Charging Dock

Table Of Contents

S/N

NP-20160330

-001

Revision

1.0

Product Design Requirements

Page

1 OF 6

GP07A

User's Manual

(Version: 1.0)

The statement

Thank you very much for you choose our products! Before using this product, please read the manual

instruction carefully. This manual all of the information subject to change without notice, the company

shall have the right at any time, to change information, without prior notice.

Summary of content (6 pages)

PAGE 1
Product Design Requirements S/N Revision Page NP-20160330 -001 1.0 1 OF 6 GP07A User's Manual (Version: 1.0) The statement Thank you very much for you choose our products! Before using this product, please read the manual instruction carefully. This manual all of the information subject to change without notice, the company shall have the right at any time, to change information, without prior notice.
PAGE 2
Product Design Requirements S/N Revision Page NP-20160330 -001 1.0 2 OF 6 CATALOG 1. Product introduction---------------------------------------------- -------------------3 1.1 Product model----------------------------------------------- -----------------------3 1.2 Function description----------------------------------------------- ----------------3 1.3 Product schematic diagram----------------------------------------------- ------------------3 2.
PAGE 3
Product Design Requirements S/N Revision Page NP-20160330 -001 1.0 3 OF 6 1. Product introduction: 1.1. Product model: P07A 1.2. Function description: P07A mobile wireless charger, the product has a built-in 890mAH polymer battery for charging Apple Watch. The product has a MicroUSB interface, which can be connected to an ordinary charger to charge the Apple Watch and charge the battery at the same time. . The product has 4 power indicator lights, which can indicate the current power and charging status.
PAGE 4
Product Design Requirements S/N Revision Page NP-20160330 -001 1.0 4 OF 6 2. Specifications 2.1 Standby power consumption ＜0.1W 2.2 Input voltage 5±0.25V 2.3 Output voltage 5±0.25V 2.4 Maximum input current ＜1A 2.5 Maximum output current ＜400MA 2.6 The ultimate conversion efficiency of the board end 83% 2.7 Ripple voltage at the output terminal <20mV 2.8 Product size 54.8*54.8*16.9mm 2.9 Product weight 53g 3. Electrical protection requirements 3.
PAGE 5
Product Design Requirements S/N Revision Page NP-20160330 -001 1.0 5 OF 6 charged.) At the same time, you can put the APPLE WATCH above the product module, and the watch will be charged while the battery is charged by the external power supply. 5.2 Charging the built-in battery When you need to use the built-in battery to charge the APPLE WATCH, you only need to click the power-on button.
PAGE 6
Product Design Requirements S/N Revision Page equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.