User Manual

10 11
Turning your Phone Clip+ ON and OFF
To turn ON your Phone Clip+ slide the ON/ OFF switch (1 on
page 8) down to the ON position. A white ”I” icon will be visible
on the base of the switch and the LED indicator will now blink
green every 2,5 seconds.
To turn it OFF, slide the ON/OFF switch up to the OFF position.
The LED will now stop blinking.
If battery level is low the LED will blink yellow every 2 seconds
indicating that the unit should be recharged.
Pairing to hearing instruments
i
Note! The following information is intended primarily for your
Hearing Care Professional, who in most cases will complete the
tasks that are necessary before the Phone Clip+ can be used
with your hearing instruments. However, the process is designed
to be simple and should be easily accomplished by almost
anyone.
Getting Started
Charging the Battery
Before using your Phone Clip+, you
need to fully charge the rechargeable
battery.
To charge it, plug the charging cable
into the Phone Clip+ as shown in the
picture to the right.
Then plug the other end of the charg-
ing cable into a power outlet.
During the charging process, the LED
indicator at the top of the Phone Clip+
will show a solid red light.
When fully charged and still connected to the charger, the LED
will turn solid green interrupted by a red blink every 2 seconds.
Charging an empty battery typically takes around 3 hours. It is
safe to leave the charger connected overnight – the battery can-
not be overcharged.
• When charging your Phone Clip+ for the first time, leave it
to charge for at least 3 hours, even if the battery indicator
shows that the unit is fully charged (see section about “Light
indicators”).
• For safety reasons, recharge the battery only with chargers
supplied by ReSound.
Do not charge the Unite Phone Clip+ while it
is on your body.