User's Manual
Airlink installation
Airlink is a USB plug and play programming interface
enabling you to fit wireless hearing Instruments from
ReSound and Beltone.
1) Before you insert the Airlink dongle make sure that
you have the correct fitting software installed. The
Airlink driver is installed during fitting software in-
stallation.
•AirlinkissupportedbyReSoundAventa3.0
(or later).
•AirlinkissupportedbyBeltoneSolusPro1.0
(or later).
2) After successful installation insert the Airlink dongle
intoanyUSBportonyourPCordockingstation.
See illustration below.
3) YouarenowreadytostartttingwirelessReSound
andBeltoneproductsusingReSoundAventa3and/
orBeltoneSolusPro1.0
Compatibility
Airlink supports the following operating systems:
WindowsXP,WindowsVistaandWindows7
•AirlinkiscompatiblewithReSoundAventa3.0(orla-
ter). Airlink works with all ReSound’s wireless (WL)
hearing instrument models released with ReSound
Aventa3.0orlater.
•Airlink is compatible with Beltone Solus Pro 1.0(or
later). Airlink works with all Beltone’s wireless (WL)
hearing instrument models released with Beltone
SolusPro1.0orlater.
Do not attempt to use Airlink together with any
other fitting software unless explicitly instructed.
Airlink can co-exist on the same PC together with
other hearing instrument programming interfaces (i.e.
Speedlink, Hi-PRO, NOAHlink)when using any other
fitting software modules.
For your safety, carefully read the chapter Important
Information.
FCCID:X26FD-1
Statement:
ThisdevicecomplieswithPart15oftheFCCrules.
Operation is subject to the following two conditions:
(1)thisdevicemaynotcauseharmfulinterference,and
(2)thisdevicemustacceptanyinterferencereceived,
including interference that may cause undesired ope-
ration.
Note: This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuanttopart15oftheFCCRules.Theselimitsare
designed to provide reasonable protection against
harmfulinterferencewhentheequipmentisoperated
in a commercial environment. This equipment gene-
rates, uses, and can radiate radio frequency energy
and,ifnotinstalledandused in accordance withthe
instructionmanual,maycauseharmfulinterferenceto
radiocommunications.Operationofthisequipmentin
a residential area is likely to cause harmful interference
inwhichcasetheuserwill be requiredtocorrectthe
interference at his own expense.
Changesormodicationscanvoidtheuser’sauthority
tooperatetheequipment.
Intended use
The Airlink USB is intended to wirelessly transfer sig-
nalsfromattingPCtowirelesshearinginstruments
denedandavailable in ReSound Aventa 3 and Bel-
toneSolusPro,enablingthettertoadjustinstrument
settings wirelessly.
List of countries
ProductsareintendedforsaleincountrieswithinEuro-
peanEconomicAreaaswellasSwitzerland.Inaddi-
tion products are intended for worldwide sales.
Theseproductsareintendedforworldwidesales,and
in compliance with the following regulatory standards:
InEU:ThedeviceconformstotheEssentialRequire-
ments according to - Annex I of Council Directive
93/42/EECformedicaldevices(MDD)-andessential
requirementsandotherrelevantprovisionsofDirective
1999/5/EC(R&TTE).Thedeclarationofconformitymay
be consulted at www.resound.com.
InUS:AlltestobjectsaresubjecttoFCCCertication
accordingtoFCCCFR47Part15,subpartC,section
15.247
FortheNorwegianmarkettheaccessoriescomplyto
EN12182TechnicalAidsfordisabledpersons.General
requirementsandtestmethodscoveredbyEMCand
electricalsafetytestsaccording toEN/IEC60601-1-2
andEN/IEC60950.
Otheridentiedapplicableinternationalregulatoryre-
quirements in countries outside EU and US. Please
refertolocalcountryrequirementsfortheseareas.