User guide ReSound Remote Control
Contents Your remote control 3 How to use your remote control 6 How to replace the battery 12 Cleaning and maintenance 16 Troubleshooting 17 Warnings 18 Regulatory information 21 2
Your remote control Introduction Thank you for choosing our products. We hope this remote control will make it easier and more pleasant for you to use your hearing aids. This user guide only contains instructions on how to use the remote control. For information on how to use your hearing aids, consult the user guide for your hearing aids. Intended use Your remote control is intended to let the user control a wireless hearing aid remotely.
Your remote control Seen from the front: 1. Button press indicator 1. 2. Volume up button 2. 3. Volume down button 4. Program selection button 3. 4.
Seen from behind: 5. Battery compartment 6. Pinhole button for pairing 7. Hole for key ring NOTE: The small padlock symbols help you ensure that the battery compartment cover is safely closed. 5. 6. 7.
How to use your remote control How to pair your remote control with your hearing aids Before you can start using your remote control, you need to pair it with your hearing aids. Just follow this simple procedure: NOTE: Your hearing care professional may have paired the remote control for you. 1. Press the pin hole button on the back of the remote control using a pointy object. After pressing the pinhole button, your remote control will remain in pairing mode for 20 seconds. 2.
3. Once the pairing is done, you will hear a sound indicator on your hearing aids. 4. Your remote control is now ready for use. WARNING: Contact your hearing care professional if you experience skin irritation while using your remote control. NOTE: Only connect the remote control to connections for which it is explicitly intended. Visual indicators The button press indicator on your remote control will light up every time you press the volume or program button.
How to adjust the volume in your hearing aids Your hearing aids adjust the sound automatically, but sometimes you may want to adjust it manually. If this is the case, follow these simple steps: 1. Press the upper part of the volume control (+) to increase the volume. 2. Press the lower part of the volume control (-) to reduce the volume. NOTE: Your hearing aids will return to your default volume setting when you turn them off and on again, or if you change programs.
NOTE: You can also mute your hearing aids by pushing the volume down button (-) for more than one second. To unmute again, simply press any button. How to change program in your hearing aids 1. Press the program button to change program. NOTE: Your hearing aids will return to your default listening program when you turn them off and on again.
1. Press the program button and keep it pressed for at least one second or until you hear a sound indicator. Your hearing aids will now start streaming sound from your wireless accessory. 2. To return to the listening program you were using before, just tap the program button. How to lock your remote control You can lock your remote control to avoid unwanted operation e.g. while carrying it in your pocket.
1. Press the program and volume down (-) buttons at the same time, and keep them pressed for five seconds. The button press indicator on top of the remote control will flash three times. 2. To unlock your remote control, repeat step one. When unlocking, the button press indicator will only flash once. NOTE: The button press indicator will flash three times every time you press any button on the remote while it is locked, but there will be no change in volume level or program choice.
How to replace the battery The battery Use a Lithium-Ion CR2032 battery for your remote control. How to replace the battery 1. Open the battery compartment using a coin. 2. Place the battery as shown in the illustration. Make sure that the + sign faces upwards.
3. Replace the battery compartment cover. Your remote control is now ready for use. NOTE: Always use new batteries recommended to you by your hearing care professional. NOTE: When you close the battery compartment cover, make sure that the coin slit points towards the locked padlock sign - otherwise it will not be safely closed. Battery warnings Your remote control is powered by a button cell battery. Read this safety information carefully before you start using your remote control: 1.
l l Never put batteries in your mouth, because Lithium-Ion batteries can cause chemical burns. Keep used and new batteries away from children, mentally disabled people and pets. 2. If you suspect that a battery has been swallowed, contact a doctor or hospital immediately. If swallowed, this type of battery can cause severe internal burns in as little as two hours, which can be fatal. 3.
6. If you cannot close the battery compartment safely and securely, stop using the remote control and keep it away from children an pets. 7. Never recharge Lithiuim-Ion batteries, as they can leak or explode.
Cleaning and maintenance How to clean your remote control 1. Clean the remote control using a dry cloth. Never use household cleaning products (washing powder, soap, etc.), or alcohol to clean the device. 2. Always keep your remote control over a soft surface when cleaning it and changing batteries. This way you can avoid dropping it on the floor. 3. Protect your remote control from excessive moisture (bathing, swimming) and heat (radiator, car dashboard). 4.
Troubleshooting Problem Possible cause Solution Button press indicator does not light up when pressing any button 1. The battery is flat 1. Change the battery 2. The battery is not placed correctly 2.
Warnings General warnings 1. Never expose your remote control to extreme heat or high humidity. 2. Do not use your remote control while driving. 3. Do not use in areas where there are explosive hazards or where there is a danger of ignition of flammable gasses. 4. X-ray radiation (e.g. CT scans, MRI scans) may adversely affect the correct functioning of this device. We recommend that you switch the device OFF before undergoing Xray procedures and keep it outside the room. 5.
8. Avoid exposing your product to rain, moisture or other liquids to protect against damage to the product or injury to you. 9. Your remote control uses low-powered digitally coded transmissions in order to communicate with other wireless devices. Although unlikely, nearby electronic devices may be affected. In that case, move the remote control away from the affected electronic device. 10. The remote control may be interfered with by other equipment.
2. If the hearing aids do not respond to the device because of an unusual field disturbance, move away from the disturbing field. 3. Do not use this device in locations where it is forbidden to use electronic devices. 4. Your hearing aids and this device were given a unique communication code during the fitting. This ensures that the device will not affect hearing aids worn by others. 5.
Regulatory information Information on temperature, transport and storage Your remote control is subject to various tests in temperature and damp heating cycling between -25°C and +60°C according to internal and industry standards. Warranty Your remote control is covered by a limited warranty issued by the manufacturer for a period of 12 months from the day of the original purchase. Please notice that extended warranties may apply in your country.
repaired at no charge for parts of labour when returned to the point of purchase. If it is determined that repair is not feasible, the entire unit may be replaced with an equivalent unit upon mutual agreement of the hearing care professional and the customer.
Europe This product is in compliance with the following regulatory requirements: In EU: The device conforms to the Essential Requirements according to Annex I of Council Directive 93/42/EEC for medical devices (MDD). Hereby, GN Hearing A/S declares that the radio equipment type RC-3 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.declarations.resound.com.
US and Canada Model: RC-3: FCC ID: X26RC-3 , IC: 6941C-RC3 This device complies with Part 15 of the FCC Rules and ISED Rules. In US: FCC CFR 47 Part 15, subpart C. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: l l l l Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications can void the user’s authority to operate the equipment.
Symbols Be aware of information marked with the warning symbol: WARNING points out a situation that could lead to serious injuries. CAUTION indicates a situation that could lead to minor and moderate injuries. Advice and tips on how to handle your hearing aid better. Equipment includes an RF transmitter. Follow instructions for use. Please ask your local hearing care professional concerning disposal of your hearing aids and accessories. NOTE: Country-specific regulations may apply.
Product is a Type B applied part. Complies with IMDA Standards DA108167 Technical specifications Operating range: Up to 3 metres Wireless technology: 2.4 GHz Operating temperature: 0-55° C Nominal RF output power transmitted: 4 dBm © 2019 GN Hearing A/S. All rights reserved. ReSound is a trademark of GN Hearing A/S.
Manufactureraccording to EU Medical Device Directive93/42/EEC: United Kingdom GN Hearing UKLtd. Kirtlington Business Centre Portway, Kirtlington Oxon OX5 3JA Tel.: +44 1869 352 800 resound.com Australia GN Hearing Australia PtyLtd Gate C, 19-25 Khartoum Road Macquarie TechnologyPark Macquarie Park NSW 2113 Tel.: (free) 1800 658 955 resound.com Singapore GN Hearing Pte. Ltd. 2 Kallang Avenue #07-19 CT HUB Singapore - 339407 Tel: +65 6320 9388 resound.
