User Manual

18 19
2. The hook switch will be activated, and your telephone’s handset will be lifted.
3. Dial the desired number when the dial tone is heard.
The headset indicator and the base’s on-line indicator will fl ash rapidly for the dura-
tion of the call.
Answering calls:
1. Press the Multifunction Button on either the headset [C] or the base [B], or open the
headset boom arm [A] if not already opened. If the headset is already being worn,
an audible beep will indicate an incoming call, after which press the Multifunction
Button.
2. An audible tone will be heard, and you are now connected to your caller.
The headset indicator and the pairing indicator will fl ash rapidly for the duration of
the call.
Ending calls:
1. Press the Multifunction Button on either the base or the headset, or close the head-
set boom arm. Your call is now terminated.
2. You may continue wearing your headset, or replace the (closed) headset boom arm
in the base for charging.
Headset handset switching (while on a call)
To switch from using the headset to the handset
during a call:
1. Pick up the telephone’s handset [A].
2. Close the headset boom arm [B], or
press the
Multifunction Button on the base [C] or the
headset [D] to continue the call on the hand-
set.
3. To end the call, hang up the telephone handset.
Note: Closing the boom arm gives you a few seconds to pick up the telephone
handset.
To switch from using the handset to the headset during a call:
1. With the boom arm open, press the Multifunction Button on either the headset or
the base.
The connection will be established shortly.
2. When the hook switch is activated, place the handset on the lifter arm.
3. To end the call, press the Multifunction Button on either the base or the headset, or
close the headset boom arm.
4. You may continue wearing the headset, or place it in the base (with the boom arm
closed) for recharging.
4.5 Battery charging
With an initial full battery charge and continual daily charging, the GN 6110’s battery will
give you years of reliable service.
Charging in the base charger
To charge in the base, place the headset into
the base. The headset indicator will light to
indicate charging, and will turn off when
fully charged.
Note: To ensure optimal charging, ensure
that the headset is placed fi rmly and com-
pletely into the base.
B
C
D
A
GN6110_contents_EU_21-10-03.indd 18-19 23-10-2003, 09:39:25