User Manual

22 23
Verifying pairing
To verify pairing, create an audio link between the headset and base by completing the
following:
1. With the boom arm open, press
the Multifunction Button on either
the headset [C] or the base [B].
An audible tone will be heard, and
the headset indicator and online
indicator will fl ash rapidly.
2. To end the audio link, press the
Multifunction Button on either the
headset or base, or close the headset boom arm.
Note: You may verify pairing at any point. However, during telephone conversa-
tions, verifying pairing is not possible.
4.7 Reset
You may reset the base to remove pairing settings and return to the default hook switch
solution setting (RHL) if needed. To reset the base, complete the following:
1. Open the compartment cover on the bottom of the base
and locate the reset button.
2. With a pointed object (such as an unfolded paperclip),
press the reset button on the base for 10 seconds [A].
When the base is reset, the pairing indicator will light for 2
seconds.
Note: If you reset the base you will have to pair your headset to the base again.
See Section 4.6 for pairing instructions.
4.8 Audio and visual indicators
The GN 6110’s headset and base have audio and visual indicators, which represent
various actions and aspects associated with setting up and operating the product.
The headset gives audio indicators and various visual indicators via its headset indica-
tor. The base gives various visual indicators via its on-line, link and general indicators.
Familiarise yourself with these indicators to fully benefi t from your GN 6110.
The headset’s audio indicators:
Headset action Audio indication
Volume Limit Repeated single high tone when min. or max.
limits achieved (when button is pressed)
Low Battery Tone Two rapid high tones repeated every 20 seconds
Out of Range No audio indications; gradual deterioration of
audio quality
Incoming Call from Mobile Ring tone A (when using mobile phone or hook
switch)
Incoming Call from desk phone Ring tone B (only when using hook switch)
Pairing Confi rmation Single high tone
Establish Audio Link Series of tones, low to high
Initiate Voice Dial Single low tone
Voice Tag not Recognised Dual high-low tone
End Call/Audio Link Closed Series of tones, high to low
Power ON/OFF No audible tone
B
C
A
G
F
E
D
C
B
A
A
~ 3 sec
GN6110_contents_EU_21-10-03.indd 22-23 23-10-2003, 09:39:26