User's Manual

• Check that the headset/handset button on top of the base unit is in headset position and that the on-line
indicators are lit up.
• Check that the battery is fully charged. If the battery is fully charged, the on-line indicator on the headset
will flah when the headset is placed in the base unit.
• Check that the serial numbers in the bottom of the base unit and on the headset match. The numbers
must match for operation.
If you hear beeps in your headset:
• A beep every 3 seconds means that the mute function is on.
• A beep every 10 seconds means that you are out of range, move closer to base unit.
• A beep every 20 seconds means that the battery is getting low and needs to be charged:
• For proper charge, make sure that the battery charging indicator is lit when the headset is placed in
base unit. If fully charged, the on-line indicator on the headset will flash.
• The battery may need up to three charge and discharge cycles to reach full capacity.
If the person, you are talking to has problems hearing you:
• Check that the mute function is off (see Step 4).
• Re-adjust the microphone volume as described in Step 9-11.
• Check the position of the boom arm and make sure that the microphone is placed at the corner of your
mouth.
• You may be out of range, move closer to base unit.
• Noise may be caused, if the base unit is placed too close to your telephone.
Maintenance
• To change or clean the ear cushion (IX), first remove the earplate and ear cushion by turning the
earplate 45° counterclockwise. Once removed, the ear cushion can be taken off the earplate.
• To clean or change the microphone foam cover, just pull it off gently.
Note: No other parts can be replaced by the user.
Safety Instructions
Read the safety instructions below. They contain important information about using GN 9010. Keep this user guide
for future use.
• GN 9010 is CE marked according to the provisions of the R & TTE Directive (99/5/EC ).
Hereby, GN Netcom as declares that this GN 9010 is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.
Please note that GN 9010 uses radio frequency bands not harmonised within EU. This means that
only model 9010-89-04 can be sold and used in Spain and France.
• Never try to dismantle the product yourself. None of the internal components can be replaced or
repaired by users.
• Avoid exposing GN 9010 to rain or other liquids.
• The headset is equipped with a rechargeable NiMH battery (nickel-metal-hydride). For replacement of
battery, please contact your vendor.
Please note that when charging the battery, the headset may become warm. This will not effect the
safety or performance of the headset.
If you have any problems or questions regarding GN 9010, please contact your vendor.