User Manual

• Press the headset’s talk button.

• Press the base’s telephone mode button.

–> The headset’s link indicator will stop ﬂashing to indicate that the headset-base link

has been closed.

Important: If using electronic hookswitch on your telephone, do not place the headset into

the charging cradle, press the headset´s talk button or press the base´s telephone mode button,

as this will disconnect the call.

If the headset runs out of battery power, the headset-base link will remain active for up to 2

minutes to allow for battery changing.

GN 9350

GN 9330

GN 9330 USB

4.6 Switching a call from desk telephone handset to headset

It’s possible to switch a call in progress from the telephone’s handset to the headset:

1. Remove the headset from base, or if already out, press

the headset’s talk button. This establishes a link.

–> The headset’s link indicator will start ﬂashing and the

call will be switched to the headset.

Note: Do not place handset before the call is over, as this will end

the call.

GN 9350

GN 9330

GN 9330 USB

4.7 New master headset pairing to base

You may designate a new master headset for your base.

Important: �efore designating a new master headset, ensure

that the original headset’s link to the base unit is closed by

pressing its talk button. The telephone or US� indicator should

not have a ﬂashing light.

To designate a new master headset:

1. Place the new master headset into the charging cradle of the base.

2. Press the base’s pairing button.

–> �oth the telephone and US� mode buttons on the base, and the headset’s link indica-

tor, will light for 2 seconds. This indicates successful pairing of the new master headset.

(