Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
Golight Stryker LED
MOUNTING INSTRUCTIONS
Light Unit/Permanent Mount
Determine the location for the light on your vehicle or boat. Remove the mounting plate from the light.
Center the mounting plate with the vise screw on the mounting plate to the back. Mark the hole
locations for the three mounting screws and drill a pilot hole for each with a 1/8 inch bit. Fasten the
stainless steel mounting plate with the 3 #10 – 16x ¾ type AB cross recessed pan head tapping screws.
Drill a ¼” hole (wireless) or a 5/8” hole (hardwired) in the center of the mounting plate opening to
accommodate the power wire or wiring harness and connector. Attach the connector that is affixed to
the underside of the light to the corresponding connector on the wiring harness (hard-wired). Position
the connection point beneath the mounting surface, and apply silicone sealant around wire to seal the
drilled opening. Wet the mounting surface with a small amount of water or lubricant for easier
installation, then place the light over the mounting plate by sliding the front of the light over the front of
the mounting plate, first pull the light backwards, then seat the back of the light on the mounting plate.
Displace the back of the gasket and install the vise screw (provided). Tighten the vise screw using a
Philips head screwdriver. Replace the gasket.
Light Unit/Magnetic Mount
Select the best location on your vehicle for the magnetic mount Stryker. Make sure the metal area
under the magnetic base is flat and clean to ensure a strong bond. Route the power cord into the vehicle
through a door frame and connect to 12V power outlet. The magnetic mount Stryker should be removed
from vehicle’s exterior while traveling at excessive speeds and in strong wind conditions.
Dash Control/Permanent Mount
Determine the appropriate location for the dash mount control and create a 2” opening to
accommodate the cylinder on the rear of the remote. Remote the outer rubber cover and affix the
control to the dash with the four screws provided. The word “TOP” is embossed on the control and
should be situated accordingly. All wiring should be undertaken with power removed from the system.
First, attach the connector on the wiring harness. Next, join the leads at the remote to 12 volt DC power
with appropriate automotive wire attachments; the red wire is the positive lead and the black wire is the
negative lead-the unit is polarity sensitive and care must be taken to observe this.
Note: Once the power is applied to the system the light will pan and tilt prior to bulb illumination. As a
safety feature, the control is backlit to indicate bulb illumination only.
Each spotlight needs to be wired on a single dedicated circuit and the power fused at 5 amps. With the
power connected, your light is ready for operation.