User's Manual

- Page 11 of 24 -

c) Insert the band of each clamp through both slots and over the

bracket [A].

d) Place the bracket [A] and hose clamps around the pole at the

approximate height where you wish to place the unit.

e) Close each clamp by reinserting the band under the screw

and rotate the screw clockwise.

f) Position the bracket in the appropriate location and tighten

the clamps around the pole so that the bracket is securely

fastened.

6. For wall mounting:

a) Fasten the wall/poll bracket [A] to the wall using four 3/16”

(5mm) bolts, as shown in Figure 3. Use the appropriate bolts

and fasteners, which is dependent on the material of the wall.

Wall-mounting bolts and fasteners are not supplied with the

mounting kit.

b) Place the wall/poll bracket [A] at the appropriate location

where you wish to place the unit. Using the four holes at the

corners of the bracket, mark the location where the fasteners

need to be installed.

c) Install the four fasteners in the wall.

d) Insert the four bolts through the bracket and securely fasten

the bracket to the wall.

Wall Mounting Holes

Figure 3: Bracket Wall Mounting