Quick Start Guide (GP-ISW-400)

Installation and Wiring - Overview
The GP-ISW should be located as close to the batteries as possible but
not within the same compartment. The length and size of the DC Cables
will affect performance. Long DC wires tend to lose efficiency and reduce
the overall performance of the Inverter/Charger.
For optimum Inverter performance the GP-ISW must be installed so the
front and rear air vents are not blocked or obstructed in any way. Do not
install the GP-ISW in an area with limited air flow. Allow as much space
around the Inverter as possible, leaving at least 4 inches of airspace
clearance around all ventilation areas.
• Flathead Screwdriver (for wire terminals)
• Philips Screwdriver (for mounting screws)
Tools and Materials Needed
Mounting Orientations
See user manual for complete instructions at gpelectric.com
LED Indicators
LED Status DC 12V DC 24V
Red
Orange
< 11.0V
11.0 ~ 11.5V 22.0 ~ 23.0V
Green 11.5 ~ 15.0V 23.0 ~ 30.0V
< 22.0V
Orange 15.0 ~ 15.5V 30.0 ~ 31.0V
Red < 15.5V > 31.0V
Input Voltage Level
LED Status Status Recovery Point
Green
Red
Normal
Over Current Protection/
Over Load Protection (AC
output short-circuit and over
load)
Under Temperature Protection/
(Heat sink temp. under -20°C)
Under Voltage Protection/
(Input DC voltage under
spec)
Over Temperature Protection
(Heat sink temp. over 80°C)
Red Blink
12.5V @ DC12V System
25V @ DC24V System
14.5V @ DC12V System
> 0°C
(Heat sink temperature)
< 60°C
(Heat sink temperature)
29V @ DC24V System
Red Fast Blink
Over Voltage Protection
(Input DC voltage over spec)
Orange
Orange Fast Blink
Orange Slow Blink
Device startup process
abnormal
-
Input Voltage Level
HORIZONTAL WALL MOUNT, BASE DOWN
HORIZONTAL MOUNT,
BASE DOWN
HORIZONTAL MOUNT,
BASE UP
VERTICAL MOUNT, DO NOT MOUNT
THE GP-ISW IN THIS CONFIGURATION
GP-ISW-R-12
Remote Control
Battery
GP-TS-30
Transfer Switch
LOAD