GP-SW Remote __________________________________________________________________________________ Owner’s Manual
GP-SW Remote ____________________________________________________________________________________________________ Table of Contents Using the Remote Control 2 Selecting Functions 2 LED Indicator 2 Important 2 Mounting the Remote 3 Mounting Template 3 1.0 Using the Remote Control 1. Turn the inverter on without the remote installed. Use the on/off switch located on the front of the inverter. 2. Plug the remote into the terminal (RS 232 Port) on the back of the inverter. 3.
GP-SW Remote ____________________________________________________________________________________________________ Step 3- Continue using the remote only to turn the inverter ON and OFF. 5.0 Mounting the Remote Step 1- Cut out the template attached and position it on the wall where the remote is to be mounted. Step 2- Mark the location of the two holes, and the square area to be cut out. Note: Remote switch assembly requires 0.7” (18mm) minimum clear panel depth. Step 3- Drill two holes, 7/64” (2.