Owners manual

REV. DATE: 4/8/2016 Page 3 of 6

Step-7 Loosen the M12 bolts (2) per side toward the end of the frame securing the bed, (Photo 5 & 6).

Step-8 Remove the M10 bolt (1) per side and M14 bolts (2) per side securing the bumper brackets to the frame,

(Photo 7).

Step-9 With assistance, remove the factory bumper and brackets by slightly lifting the bed off the frame, and

pulling the bumper rearward away from the vehicle, (Photo 8). Tighten the bolts securing the bed

Step-10 Remove the license plate, disconnect the license plate lights, and If equipped disconnect the backup

sensors from the factory bumper wiring harness.

Step-11 Remove the wiring harness from the factory bumper.

BR20 Bumper Replacement Installation

Note: if your vehicle is not equipped with rear Park Assist install the supplied round plugs in the holes in the

replacement bumper and proceed to Step 7.

Note: If you are replacing a bumper with rear Park Assist, the sensor detection zone will be altered with use of

this bumper replacement.

Driver

Side

Driver

Side

Driver

Side