Owners manual

ManualsBrandsGO RHINO ManualsAutomotiveGo Rhino D24235PS Dominator D2 SideSteps Fits 15-19 Canyon Colorado

1 | P a g e

Parts List

Read the installation instructions completely and verify that all of the parts listed are accounted for. If you

have defective, missing or damaged parts or need assistance, please contact Go Rhino Products for fast,

friendly customer service at: 1-888-427-4466 or email: warranty@gorhino.com

No.

Qty.

Part #

Description

Torque

D242356AA

Bracket (passenger side)

D242356AA

Bracket (driver side)

Passenger Side Step

Driver Side Step

M8-1.25 x 25mm Hex Bolt

20 Ft. Lbs

M8-1.25 Clip-Nut

M8-1.25 Hex Nut

5/16" Flat Washer

5/16" Lock Washer

Installation Instructions

Dominator D2 Side Steps Part Number D24325 (T-PS)

2015-2016 Chevrolet Colorado & GMC Canyon Crew Cab

Do not attempt to install this product on any vehicle other than the one listed above!

Tool Required:

13mm Socket

13mm Wrench

Ratchet & Ratchet Extension

Approximate installation time: 60 min

Bracket (passenger side)

Bracket (driver side)

Summary of content (4 pages)

PAGE 1
Installation Instructions 23 (T-PS) Dominator D2 Side Steps Part Number D24325 2015-2016 Chevrolet Colorado & GMC Canyon Crew Cab Do not attempt to install this product on any vehicle other than the one listed above! Parts List No. Qty. Part # Description 1 4 D242356AA Bracket (passenger side) 2 4 D242356AA Bracket (driver side) 3 1 Passenger Side Step 4 1 Driver Side Step 5 32 M8-1.25 x 25mm Hex Bolt 6 16 M8-1.25 Clip-Nut 7 16 M8-1.
PAGE 2
Installation This installation uses 4 brackets per side, (Photo 1). Photo 1 1 1 1 1 Step-1 Begin the installation on the passenger side. Starting at the front of the vehicle, locate and remove the plastic plugs in the back side and bottom of rocker panel to expose the holes used for placement of the M8 Clip- Nuts, (Photo 2). Step-2 Install M8 Clip-Nuts in the rocker panel with the threaded end centered over the smaller hole, (Photo 3).
PAGE 3
Step-3 Attach one of the passenger side brackets to the rocker panel using (2) M8 hex bolts, (2) 5/16” flat washers and (2) 5/16” lock washers, (Photo 4 & 5). Leave the bolts loose for final adjustment. Photo 4 Passenger Side Front Photo 5 Passenger Side Front 1 1 Step-4 Locate the plastic plugs and holes in the rocker panel at the center and rear of the cab, and repeat steps1-3 to install the 3 remaining passenger side brackets, (Photo 6 & 7). Leave the bolts loose for final adjustment.
PAGE 4
Step-5 Attach the passenger side step to each bracket using (2) M8 hex bolts, (4) 5/16” flat washers, (2) 5/16” lock washers, and (2) M8 hex nuts, (Photo 8 & 9). Photo 8 Passenger Side Front Photo 9 Passenger Side Rear Step-6 Align the side step with the vehicle and tighten all bracket and side step nuts and bolts, (Photo 10). Repeat the above steps to install the driver side brackets and side step. Remember to check and retighten the bolts periodically.