DVD Recorder + VCR User Manual VR2945

ManualsBrandsGo-Video ManualsDVRVR2945

INTRODUCTION

Connections

Connecting Antenna/Cable

CONNECTIONS

Disconnect the antenna/cable from the rear of your

TV.

Connect this cable to the jack marked RF IN (FROM

ANT.) on the rear panel of the DVD Recorder+VCR.

Cable Service Without Cable Box

If your cable wire is connected to your TV without a

converter or descrambler box, unscrew the wire from your TV and attach it to the RF IN (FROM ANT.) jack on the

rear panel of the DVD Recorder+VCR.

Use the supplied coaxial cable to connect between the DVD Recorder+VCR’s OUT (TO TV) jack and the antenna

input jack on your TV. With this connection, you can receive all midband, superband, and hyperband channels

(all cable channels).

Cable Service With Cable Box

If a cable box is required in your cable system, follow

the instructions shown at right. This hookup permits

both TV and DVD Recorder+VCR operation.

To view or record a CATV channel:

Tune the TV to the correct video input channel.

Set the DVD Recorder+VCR to the output channel of

the cable box using the [CH …/†] or the [0-9] keys

on your DVD Recorder+VCR (e.g., CH3).

Select the channel you wish to view on the cable

box.

• There are a variety of ways to connect the DVD Recorder+VCR to your TV and other equipment. Use only one of

the connections described below. Whichever TV connection you use will work with all input sources.

• Please refer to the manuals for your TV, VCR, stereo system, or other devices as necessary to make the best

connections.

• For better sound reproduction, connect the DVD Recorder+VCR’s AUDIO OUT jacks to the audio in jacks of your

amplifier, receiver, stereo, or audio/video equipment. See ‘Connecting an Amplifier/Receiver‘ on page 18.

• If you are using a cable box to tune channels, it is not necessary to run Auto Channel Search as indicated on page

23.

Caution

• Make sure the DVD Recorder+VCR is connected directly to the TV, and the TV is set to the correct video input.

• Do not connect the DVD Recorder+VCR’s AUDIO OUT jack to the phono in jack (record deck) of your audio system.

• Do not connect the DVD Recorder+VCR via your VCR. The DVD image could be distorted by the copy protection

system.

DEO

OUT

DIGITAL

AUDIO OUT



AUDIO OUT COMPONENT OUT

LINE 2

AUDIO

VIDEO

R

COAXIAL

Y

Pb

Pr

RF OUT

ANT. IN

DVD & VCR OUT

Antenna Antenna

Flat Wire

(300 ohm)

300/75 ohm

Adaptor

(Not supplied)

Cable TV

Wall Jack

OR OR

Rear of DVD Recorder+VCR