DVD Recorder + VCR User Manual VR2945

62
Troubleshooting
Camcorder image via A/V
input to DVD Recorder+VCR
is not shown on TV screen.
Can’t play disc recorded
on this DVD Recorder+VCR
on another DVD player.
Cannot record or did not
record successfully.
Timer Recording not
possible.
Stereo Audio Record and/or
Playback not present.
Remote control does not
work properly.
DVD Recorder+VCR’s source is not
set to LINE1/LINE2 composite.
The disc was not finalized (or not
made compatible if using a DVD+RW).
Some players will not play even a
finalized disc.
Discs recorded with copy-once
material cannot be played on other
players.
The remaining blank space on the
disc is insufficient.
The source you are trying to record
is copy-protected.
When setting the recording channel,
the channel is tuned on your TV’s tuner.
Clock in DVD Recorder+VCR is not
set to correct time.
Timer has been programmed
incorrectly.
TIMER indicator light does not
appear after programming timer.
TV is not Stereo-compatible.
Broadcast program is not in stereo
format.
DVD Recorder+VCR A/V Out jacks
are not connected to TV A/V In
jacks.
DVD Recorder+VCR Audio/Video Out
is not selected for viewing at the TV.
DVD Recorder+VCR’s TV audio
channel is set to SAP or MONO.
The remote control is not pointed at
the remote sensor of the DVD
Recorder+VCR.
The remote control is too far from
the DVD Recorder+VCR.
There is an obstacle in the path of
the remote control and the DVD
Recorder+VCR.
The batteries in the remote control are dead.
The remote control is locked.
Use INPUT to select AV input channel
(LINE1/LINE2 composite).
Finalize the disc; see page 54.
No solution.
No solution.
Use another disc.
You cannot record the source.
Select the channel on the DVD
Recorder+VCR’s built-in TV tuner.
Set clock to correct time. See ‘Set Clock‘
on page 24.
Reprogram Timer. See ‘Timer Recording‘
on page 49.
Reprogram Timer.
No solution.
No solution.
Make A/V connections. Stereo is
available only via A/V output from DVD
Recorder+VCR.
Select AUX or A/V source as TV input.
Set TV audio channel mode to Stereo.
See ‘Changing the TV Audio Channel‘ on
page 36.
Point the remote control at the remote
sensor of the DVD Recorder+VCR.
Operate the remote control within 23 ft
(7m).
Remove the obstacle.
Replace the batteries.
Press and hold POWER key on font over 5
seconds.
Symptom Cause Solution
DF-L72B1N-BS(GB) 04.7.1 3:10 AM 페이지62