Product Guide

1110
Q: Can I use third party, non-Goal Zero lead-acid batteries with the Link?
A: Yes, you can use any 12V SLA or AGM deep cycle lead acid battery with
the Link. However, you will need a Goal Zero Female Link Chaining Cable
to connect your batteries to the Link.
Q: If I’m using my own third party lead acid batteries, how do I wire them
up?
A: When connecting multiple 12V lead-acid batteries to your Link, be sure
to connect the batteries in parallel. Parallel connections will increase your
current rating, but the voltage will stay the same.
WARNING: Connecting batteries in series will increase the voltage, causing
damage to the unit and possible personal injury or death.
Q: How many lead acid batteries can I plug into the Link?
A: You can attach as many 12V lead-acid batteries to your Link as you’d like.
Q: How fast will the Link charge the Tank(s) using the Yeti power supply?
A: Plugging the Yeti power supply into your Link will provide 5A of power into
your Tank. At this rate, it will take around 20 hours to charge each Tank.
Q: Why is my Link only charging my Yeti up to 98%?
A: The Link will only charge a first generation Yeti Lithium to 98%. This
protection is in place to protect and prolong the life of your battery.
Second generation Yeti Lithium power stations equipped with the latest
firmware updates can be charged to 100%.
TECHNICAL SPECIFICATIONS
65 Amp Charge Controller
Charges the following:
GOAL ZERO Yeti 1000 @ Max Input 454-605W
GOAL ZERO Yeti 1400 @ Max Input 454-750W
GOAL ZERO Yeti 3000 @ Max
Input
750W
Ports: Do not exceed 22V Input
8mm Charging port 14 - 22V, Do not exceed
150W per port
External Battery Connector
(Output)
65A charge controller
10.7 - 15V
General:
Weight 1.5 lbs (680 g)
Dimensions 10.25 x 3.3 x 1.5 in (26 x
8.4 x 3.8 cm)
Warranty 12 months
Certs
Yeti Link Expansion Module