User Manual

ManualsBrandsGoalrilla ManualsSoccer GoalsPortable 4' x 6' Gamemaker Soccer Goal Sets Up on Any Surface in 90 Seconds Great for Indoor or Backyard Play

O W N E R ' S M A N U A L

MODEL NUMBERS:

Please Do Not Return This Product To The Store!

Contact Escalade Sports customer service department at:

Phone: 1-888-USA-GOAL Toll Free !

Fax: 1-866-873-3536 Toll Free !

E-mail: Training@escaladesports.com

Mailing Address:

Escalade Sports

PO Box 889

Evansville, IN 47706

Please visit our World Wide Web site at: www.G oalrilla.com

ON-LINE TROUBLE SHOOTING TECHNICAL ASSISTANCE

ON-LINE PARTS REQUESTS FREQUENTLY ASKED QUESTIONS

ADDITIONAL ESCALADE® SPORTS PRODUCT INFORMATION

2L-7552-01

Escalade® Sports products may be manufactured and/or licensed under the following patents.

6419596, 6179733, 5919102, 5071120, 4798381, 4424968, D326128

Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product.

2013 Escalade Sports

GM0064W - GM 4’X6’ GOAL

GM0085W - GM 5’X8’ GOAL

GM0126W - GM 6’X12’ GOAL

GM0217W - GM 7’X21’ GOAL

GM0248W - GM 8’X24’ GOAL

GM0127W - GM FUTSAL GOAL

PLEASE READ AND FOLLOW THIS MANUAL IN ITS ENTIRETY BEFORE USE. DOING SO WILL PROVIDE

HELPFUL HINTS THAT WILL AID IN GETTING MAXIMUM USE OUT OF YOUR GAMEMAKER GOAL.

PLEASE VISIT FOR VIDEO INSTRUCTIONS

1. Do not store in temperatures below 32⁰ F. and above 100⁰ F.-Be aware of keeping your Gamemaker in trunk

of cars or garages that could reach these temperatures.

2. If accidentally left at the temperatures above, allow it to reach room temperature before inflating.

3. Do not drag your Gamemaker Goal on concrete, asphalt or gravel.

4. Always use the rollout tarp and follow steps 5 and 6 on page 7 in this manual, whenever storing your

Gamemaker Goal.

5. Please make sure to secure your Gamemaker Goal before each use. Stakes on grass, and other soft areas.

Sandbags (provided) or water bags (sold separately @ Goalrilla.com) on turf, Gym floors and other hard

surfaces.

6. Check bags and all pockets before assembling or ordering parts.

7. Save these instructions and your proof of purchase (receipt) in the event that the manufacturer has to be

contacted for replacement parts.

WWW.GOALRILLA.COM

Summary of content (8 pages)

PAGE 1
MODEL NUMBERS: GM0064W - GM 4’X6’ GOAL GM0085W - GM 5’X8’ GOAL GM0126W - GM 6’X12’ GOAL GM0217W - GM 7’X21’ GOAL GM0248W - GM 8’X24’ GOAL GM0127W - GM FUTSAL GOAL OWNER'S MANUAL PLEASE READ AND FOLLOW THIS MANUAL IN ITS ENTIRETY BEFORE USE. DOING SO WILL PROVIDE HELPFUL HINTS THAT WILL AID IN GETTING MAXIMUM USE OUT OF YOUR GAMEMAKER GOAL. PLEASE VISIT WWW.GOALRILLA.COM FOR VIDEO INSTRUCTIONS 1. Do not store in temperatures below 32⁰ F. and above 100⁰ F.
PAGE 2
WARNING ADVERTENCIA FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE EL NO CUMPLIR CON ESTAS ADVERTENCIAS PUEDE RESULTAR EN LESIONES PERSONALES Y/O DAÑOS MATERIALES. • Never Play on Damaged Equipment, Inspect Before Each Use • Not to be Used as a Flotation Device • Intended For Use By Ages 9 and Up • Do Not Wear Jewelry, Watches Ect. While Using Product, Objects Can Entangle In Net.
PAGE 3
PARTS LIST GM0248W - GAMEMAKER 8’X24’ Part # 3A-6073-00 3F-6063-00 3A-6071-00 2S-9256-00 4A-7894-00 3A-6066-00 3M-8961-00 5A-7958-00 3A-6068-00 2L-7551-00 2L-7552-01 Description GM FRAME NET LARGE PUMP STAKES SAND BAGS NOZZLE ZIP TIES (BLACK) REPAIR KIT HOSE INSTRUCTION CARD MANUAL GM0085W - GAMEMAKER 5’X8’ Qty. Part # 1 1 1 10 6 1 14* 1 1 1 1 3A-6069-00 3F-6060-00 3A-6067-00 2S-9256-00 4A-7894-00 3A-6066-00 3M-8961-00 5A-7958-00 3A-6068-00 2L-7551-00 2L-7552-01 *14 extra zip ties use as needed.
PAGE 4
INFLATING THE GAMEMAKER Transporting the Gamemaker STEP 1: goal onto a level surface. After carrying (Do Not Drag) GameMaker bag to desired location, place the bag on the ground, carefully unzipping the top and front zippers. (Make sure not to place goal on concrete, rocks, or other rough surfaces) Roll out the roll up tarp (Containing GameMaker goal, Pump, and Hose) and remove the GameMaker from the clear plastic bag.
PAGE 5
STEP 5: Inflating the GameMaker Goal. Begin pumping to inflate GameMaker. When the pump can no longer be pumped, your goal is fully inflated. Please note that it might be necessary to adjust your GameMaker during inflation, if any kinks form, to allow the air to easily flow through the tubes. STEP 6: Setting up your GameMaker Goal. After the GameMaker is inflated to the desired stiffness, remove the hose, and screw the valve cap back on.
PAGE 6
DEFLATING THE GAMEMAKER STEP 1: Before Deflating clear the area. After use, ensure the goal area is clear of all obstacles and people before beginning the deflation process. Leave all ground anchors in place. STEP 2: Deflating the GameMaker. Before removing any ground stakes or sandbags, make sure the area around the goal is clear, and place valve in the deflate position. This is done by pushing in the valve and twisting clockwise. BEWARE, the valve will be difficult to push in.
PAGE 7
STEP 4: Properly Setting the Pump for Deflation. Remove the pump hose from the “inflate” port of the pump and attach it to the “deflate” port (Located on the opposite side of the pump). The top of the pump states which side is for inflation and deflation. Insert the other end of the hose into the GameMaker valve. The pump hose does not need to be forcefully inserted into the opening, doing this may damage your valve.
PAGE 8
GameMaker (All Sizes) 1 YEAR LIMITED WARRANTY This consumer warranty extends to the original consumer purchase of any Escalade Sports Product (hereinafter referred to as the “Product”). ® WARRANTY COVERAGE: E scal ade Sports warrants to the original Consumer Purchaser that any Product of its manufacture is free from defec ts in material and workmanship.