User Manual

1
4
4
3
2
Fig. 2 shows the unit mounted on the support H0564.
Fig. 3 shows the unit directly mounted on the main aluminum plate.
Use your judgment to decide whether you need to install your FBL unit as shown in Fig 2 or
Fig 3. This will depend on the size of the FBL unit itself and the arrangement of the wires.
With larger units, the nylon nut can make it difficult to connect the wires to the unit, in this
case it is recommended to use the aluminum support H0564.
With smaller units, the unit can be installed directly onto the main plate.
This facilitates boom removal in the future if necessary.
We recommend using some type of adhesive to prevent the servo wires and connections
from coming unplugged from the receiver or FBL unit. You can use hot glue for this purpose.
FBL Unit
Double-
sided Tape
Bag 9
FLYBARLESS CONTROL UNIT AND RX INSTALLATION
We suggest the use of a “single unit” FBL system (all in one type unit).
This allows for easier wire routing considering the small size of this helicopter.
Position 1 can be used to install the FBL unit.
Position 2, 3 and 4 can be used to install a small RX unit or satellite.
FBL Support
(H0564-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Page 18
Chapter 12, Installation Of Flybarless Unit and RX