User Manual

Aprrox 0-0.5mm
Socket Head Cap
Screw M4x10mm
(HC102-S)
TAIL BOOM ASSEMBLY
To fit the tail belt, loosen the tail boom by loosening the 2 M3 screws (Fig.1).
*Install the belt onto the front tail pulley, checking the direction of rotation.
*Rotate the tail drive several times by hand.
*Tension the tail belt by using the tool kit to slide the boom backwards. Then slowly tighten the two red screws.
How to use the tail belt tension tool:
1. Push the plastic pad into its seat by unscrewing the orange M4x10 screw.
2. Install the tool on the boom, it needs to touch the H1372 clamp.
The yellow M3 set screw can be used to make sure the tool is parallel to the boom clamp.
3. Tighten the pink M4x10 screw to lock the tool onto the boom.
4. Turn the orange M4x10 screw to tension the tail belt.
This will push the boom back, thus tightening the tail belt.
5. Once the correct tension is achieved, tighten the two boom clamps with the two M3 screws.
6. Remove the tool before flight.
NOTE: Be sure that the
servo wire does not get
in contact with the belt.
NOTE: Correct Tightening
[H1402-01]
[H1402-02]
[H1402-03]
Oring
Set Screw M3x20
[HC150-S]
Nut M3
[HC206-S]
Screw M3x18
[HC079-S]
Screw M4x10
[HC102-S]
Tighten the Screw
for tension the belt
TOOL KIT ASSEMBLY
Box 2, Bag for page 28
NOTE: Correct Tensioner
Parallel to the Frame
Page 28
TAIL BOOM ASSEMBLY