User Manual

Canopy
Boom
Foam Box
Bag Box
Blades Holder
Blades, Tail Blade,
Carbon Rod
Landing Gear Bag
2 Low Side Frame
Manual
Product Card
Extra Card
*Generic pliers.
*Hexagonal driver, size 1.5, 2, 2.5, 3mm.
*4/5mm T-Wrench.
*5.5mm Socket wrench (for M3 nuts).
*8mm Hex fork wrench (for M5 nuts).
*Medium threadlocker (SAB p/n HA116-S).
*Strong retaining compound (SAB p/n HA115-S).
*Spray lubricant (eg. Try-Flow Oil).
*Synthetic grease (eg. Microlube 261).
*Cyanoacrylate adhesive.
*Pitch Gauge (for set-up).
*Soldering equipment (for motor wiring).
*Electronic Motor
*Speed controller
*Batteries: 12S – 4200/5500mAh
*1 flybarless 3 axis control unit
*Radio power system.
*3 cyclic servos
*1 tail rotor servo
*6 channel radio control system on 2.4 GHz
The assembly process is described in the following chapters.
Each chapter provides you with the box, bag and/or foam
numbers you will need for that chapter. The information
is printed in a black box in the upper corner of the page.
INSIDE THE MAIN BOX THERE ARE:
Green screw and Green bearing
in the illustration means you
need to use:
Use retaining compound
( SAB HA115-S )
Use Proper Lubricant Use CA Glue
Indicates that for this
assembly phase you need
materials that are:
Foam xxx, BAG xxx.
Important
ADDITIONAL COMPONENTS REQUIRED TOOLS, LUBRICANTS, ADHESIVES
Blue screw and blue bearing
in the illustration means you
need to use:
Thread Locker Medium
Strength
( SAB HA116-S)
Foam xx, BAGxx
NOTES FOR ASSEMBLY
Please refer to this manual for assembly instructions for this model. Follow the order of assembly
indicated. The instructions are divided into chapters, which are structured in a way that each step is
based on the work done in the previous step. Changing the order of assembly may result in additional
or unnecessary steps.Use thread lockers and retaining compounds as indicated. In general, each bolt
or screw that engages with a metal part requires thread lock. It is necessary to pay attention to the
symbols listed below:
Page 4
NOTE FOR ASSEMBLY