User's Manual

功能介绍

Features

Call Alert (Private call only)

Call alert can be used to get a hold of someone quickly for requesting

the recipient to call back. Call alert are repeated until response to. To

respond, the recipient can talk back.

1. The methods of sending “Call Alert” are as follows:

Enter “Menu” – “Contacts” – “Contact List”, select the contact to

whom a call alert will be sent for conrmation, enter “Server”, and

select “Call Alert” for sending.

Enter “Menu” – “Contacts” – “Dial”, enter the other party’s device ID

for conrmation, and select “Call Alert” for sending.

Press “#” on the standby interface to enter the dial-up interface,

enter the other party’s device ID under the private call type for

conrmation, and select “Call Alert” for sending.

Congure “One touch call” through CPS and send “Call Alert”.

2. After “Call Alert” is sent successfully, it will prompt “Send OK”,

otherwise it will prompt “Send Fail”.

3. After “Call Alert” is received, a display interface will pop up, showing

the sender’s ID or alias, and the alert tone will continue to sound.

Remote Monitor (Private call only)

Remote monitor is used to send a command to the other party, and the

other party’s device sends a voice to the command sender in a secret

state to achieve the purpose of monitoring the other party.

1. The transmission duration of monitoring voice can be congured

through CPS.

2. The monitored party’s device sends voices secretly without any alert

on the interface.

3. The interface for receiving remote monitor voices is the same as the

interface for receiving private calls.

4. The methods of sending “Remote Monitor” are as follows:

Enter “Menu” – “Contacts” – “Contact List”, select the contact to

功能介绍

Features