User's Manual

功能介绍

Features

by execute “Rad Disable” command.

1. The methods of sending “Kill” are as follows:

Enter “Menu” – “Contacts” – “Contact List”, select the contact to

whom will be sent for conrmation, enter “Server”, and select “Rad

Disable” for sending.

Enter “Menu” – “Contacts” – “Dial”, enter the other party’s device ID

for conrmation, and select “Rad Disable” for sending.

Press the “#” key on the standby interface to enter the dialing

interface, enter the other party’s device ID under the individual call

type for conrmation, and select “Rad Disable” for sending.

Congure “one touch call” through CPS to send “Rad Disable”.

2. After “Rad Disable” is sent successfully, it will prompt “Send

Successfully”, otherwise it will prompt “Send Failed”.

3. The interface will display “Rad Disable” immediately after receiving

it. At the same time, no “Menu” and “Buttons” except ON / OFF

device. It can only be restored to normal through congure software

CPS or receiving the “Rad Enable” command.

Radio Enable /Activate (Private call only)

It is used to restore the device that was inhibited to normal.

1. The methods of sending “Activation” are as follows:

Enter “Menu” – “Contacts” – “Contact List”, select the contact to

whom “Rad Enable” will be sent for conrmation, enter “Server”, and

select “Rad Enable” for sending.

Enter “Menu” – “Contacts” – “Dial”, enter the other party’s device ID

for conrmation, and select “Rad Enable” for sending.

Press the “#” key on the standby interface to enter the dialing

interface, enter the other party’s device ID under the individual call

type for conrmation, and select “Rad Enable” for sending.

Congure “one touch call” through CPS to send “Rad Enable”.

2. After “Rad Enable” is sent successfully, it will prompt “Send

Successfully”, otherwise it will prompt “Send Failed”.

功能介绍

Features