Instructions / Assembly

8
Hook .
X
1/8"1/8"
2.5
Hook
Mark the screws position with provided screw marker.
2
Extend the track to the width you need
IF INSIDE MOUNT:
Minimum 2.5” depth needed.
Not required for ceiling mount
5
Make sure the mounting brackets are tightened inside the groove.
3
Cut down the cardboard B and use it to mark the central screw point.
Align cardboard A against the left side and mark 2 screw points, vice versa.
Make sure mounting surface is FLAT.
Keep the mouting brackets adjustable.
middle
2 in17 in
2.25 in 2.25 in 2.25 in




2 in 17 in
2.25 in
2.25 in2.25 in
6
Apply the anti fray clips to two sides of panels.
Attach panels on the sliding rails.
7
Extend the track to the width you need (maximum 86”)
4
Attach the track to the mounting brackets.
We recommend additional hand to finish this step.
Use Allen wrench to screw set screws into the bottom rails.
Caution! All the brackets must be correctly and firmly installed.
a
b
c
d
e
f
Ceiling Mount
0.3 in
2.25 in
Note: If you don’t want to use the screw marker, you can also use a tape measure
to draw screw points, 5 screw points must be on the same level.
Lock the middle bracket inside the groove first
and then lock the other 4 brackets.
5
5
5