User's Manual

STE5 Operation Manual
32
6-3. Print Line Adjustment
To get better printing balance and
quality, use print head adjusting gear
to adjust the contacting surface
between print head and label.
1. When turning print head
adjusting gear counter-clockwise
(as arrow 1 shows), print head
would move in the direction
where arrow A shows.
2. When turning print head
adjusting gear clockwise (as
arrow 2 shows), print head
would move in the direction
where arrow B shows.
A
B
1
2
6-4. Adjust the cutter
1. A cutter-adjusting hole is present
on the side of cutter (where A is
pointing to).
2. The cutter will not work properly if
there is a paper jam. Turn the
power off and use a #M3 hexagon
wrench inserted into hole “A”, and
then turn it counter-clockwise.
3. Power on the printer after clearing
the paper jam, the cutter will reset
automatically.
Note
The label / paper used for cutting is
suggested to be at least 30mm in
height.
A