User manual

EZ2000 Plus / EZ6000 Plus User Manual
23
The following table lists descriptions of the available settings and options:
Darkness
Speed
Default: 10
Sets the temperature during printing. Values range from 0 to
19, the default setting is 10.
Sets the print speed (inches per second (ips))
Stop position
Default: 12
The stop position determines how far the printed label is
moved out (tear-off position / cut-off position)
Adjust stop position
Default: 0
Adjusts the printer's stop position. Values range from 0 to 10.
Vertical position
This value changes the stop position, irrespective of the driver
or software settings.
Printing mode
Default: 0
Sets the 0 position of the print head. Values range from -100
to 100.
Default: Thermal transfer
Thermal transfer: Requires a ribbon to transfer a printed
image to a label.
Direct thermal:
Accessories / options
No ribbon is required for printing, but a direct
thermal print medium must be loaded.
Default: Option disabled
Dispenser mode: Select to enable the dispenser mode.
Cutter mode: Select to enable the cutter mode.
Option disabled:
Paper settings
Select this setting to disable both options.
Default: Die-cut labels
Black marks: For labels or normal paper with black marks on
the reverse side.
Die-cut labels: For die-cut labels on label liner or labels with
tag holes
Continuous medium:
RS232 (serial) settings
For continuous label stock
Baud rate:
Default: 9600 bps (bits per second)
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
Parity:
Default: None
None
Odd
Even
Data length:
Default: 8 bits
7 bits
8 bits
Stop bit:
Default: 1 bit
Sensor type
1 bit
2 bits
Default: Automatic
Automatic: Automatic detection of label type (labels with
black marks, die-cut labels, or continuous label stock) and
label height
Gap mode: For die-cut labels on label liner or labels with tag
holes
Reflective mode:
For labels or normal paper with black
marks on the reverse side.