Manual

3. Accessory
3-1. Stripper Module Installation
1 Stripper Module
2 Screw x 2pcs
【 Note1 】 Please power off
the printer before installing the
stripper module.
【 Note2 】 Label liner thickness
is recommended to be 0.06mm
± 10% with basic weight
65g/
㎡ ± 6%.
【 Note3 】 The max width for
stripper is 110mm (for DT-4)
and 54mm (for DT-2).
2
1
1. Place the printer on a
horizontal surface and
open the Top Cover.
2. Remove the Front Cover
Piece.
【 Note 】
You can also use coin or
screwdriver to open the Front
Cover Piece.
3. Push the Stripper
connector into printer
through the cable hole as
shown in figure.
4. Place the Stripper on the
fillister. Align the Stripper
with 2 notches on the
fillister.
EZ-DT-2/EZ-DT-4 User’s Manual
15