GODOX设计文件图注 项目类型 说明书 产品料号 705-WMYCS1-00 项目名称 尺寸(mm) 尺寸公差 材质 工艺说明 备注/色值 设计师 UHF无线麦克风系统⸺WMicS1 版本 A 100x140mm ±2mm 骑马钉 105g铜版纸 正反印刷,单色 胡宾 校对 赖慧怡
神牛微信公众号 Follow Wechat Public Account 说明手册 Instruction Manual QC PASS 深圳市神牛摄影器材有限公司 地址: 深圳市宝安区福海街道塘尾社区耀川工业区厂房2栋 电话: +86-755-29609320(8062) 传真: +86-755-25723423 GODOX Photo Equipment Co., Ltd. 邮箱: godox@godox.com Add: Building 2, Yaochuan Industrial Zone,Tangwei Community, Fuhai Street, Bao’an District, Shenzhen 518103, China Tel: +86-755-29609320(8062) Fax: +86-755-25723423 E-mail: godox@godox.com godox.
前言 欢迎使用UHF无线麦克风系统⸺WMicS1,本产品非常适用于摄影录制,现场采访及语音 录制等场合。请仔细阅读本说明书,以便能正确的操作,发挥本产品的优越性能。 部件名称 腰包发射器(TX1) 产品特点 • • • • • • • • • UHF频率范围:514MHz-596MHz 96个无线频道可选,有效减少热频干扰 无线距离最大可达100m OLED显示屏提供各项参数设置 3.
标配物品 便携接收器(RX1) 1 腰夹 6 2 3 4 5 1. 天线 2. 3.5mm 音频线输出接口 3. Power 指示灯 - 绿灯:电量充足 - 红灯:电量低,需换电池 4. 电源 / 返回键 5. 菜单键 8 11 14 9 12 15 10 13 6. 3.5mm 耳机监听接口 12. 金属背夹接口 - 绿灯:RF 信号强 13. 电池盒 - 两节 5 号电池 - 红灯:RF 信号弱或已断开 14. 产品标签贴 8. OLED 显示屏 15. 1/4 冷靴接口 9. 音量 +/ 菜单 + 10. 音量 -/ 菜单 - 1 2. B 组射频信号 3. 电池电量显示 6. 同步发射器电量及输入音量 发射器 11. USB Type-C 7. RF 指示灯 1. A 组射频信号 5. B 组接收频道 全向型领夹式 麦克风 3.5mm 插头音频线 7 OLED显示屏: 4.
可搭配产品 Version 1.
二、接收器设置 • 开关机:长按 2 秒电源开关按键即可开 / 关机; • RCVR/CH/VOL 设置:当需要设置 A 组别参数时,在显示 A 组别参数时长按菜单键进 入设置界面,再短按菜单键切换下一个设置,需要设置 B 组别参数时,则需在显示 B 组别参 数时长按菜单键进入设置界面。 A B RCVR-A ON CH: 01 VOL: 25 514.
故障排除 发射器 ① 将全向型领夹式麦克风插入发射器的“MIC”接口; ② 打开发射器,设置相应参数; ③ 用腰夹将发射器夹在腰带上或将发射器直接放进口袋里。 接收器 ① 将 1/4”冷靴连接到接收器,并将其安装在相机 / 摄影设备上; ② 将 3.
产品保修 尊敬的用户,本保修卡是申请保修服务的重要凭证,请您配合销售商填写并妥善保管,谢谢! 产品信息 型号 用户信息 通信地址 姓名 产品条码 联系电话 名称 销售商信息 备注 联系电话 通信地址 产品保修和服务支持信息 产品的保修期和服务类型按以下《产品保修信息》执行: 销售日期 产品类别 注:此表应由销售商盖章确认。 产品信息 本文件适用于相关《产品保修信息》( 见后面说明 ) 所列产品,其他非属此范围的产品或部件 ( 如促销品、赠品及其他出厂后附加的部件等 ) 不在此保修承诺内。 保修期 产品及部件的相应保修期按相关的《产品保修信息》执行。保修期自产品首次购买日起算,购 买日以购买产品时保修卡登记日期为准。 如何获得保修服务 不适用保修的情况 如产品存在下列清况,本文件项下的保证和服务将不适用 ① 产品或部件超过相应保修期; ② 错误或不适当使用、维护或 保管导致的故障或损坏,如:不当搬运;非按产品合理预期用 途使用;不当插拨外接设备;跌落或外力挤压;接触或暴露于不适当温度、溶剂、酸碱、水浸 或潮湿环境;③ 由非神牛授权机构或人员安装、修理、更改、添加或拆卸造成的故
Forward Names of Parts Thank you for purchasing UHF Wireless Microphone system-WMicS1. These products are suitable for video recording, journalistic shooting, audio recording, etc. Please read this manual carefully before using to make sure the correct operation and exert the optimum function.
Included Item Portable Receiver(RX1) 1 Belt Clip 6 1/4"Shoe Mount Adapter 2 3.5mm Audio Cable 3 4 5 1. Antenna 2. 3.5mm Audio Output Port 3. Power Indicator -Green light: full battery level -Red light: Low battery level, replace the batteries 4. Power Source/Mute Button 5. Menu Button 7 8 11 14 9 12 15 10 13 Transmitter XLR To 3.
Recommended Combination OLED Light 5 • Display brightness setting: short press +/- button until OLED light is displayed on the panel. Then, long press the menu button to choose the corresponding brightness level of OLED light. Short press +/- button to choose brightness from 1 to 8 levels.
Receiver Setting • Power On/Off: long press the button for 2 seconds to power it on or off. • RCVR/CH/VOL setting: to set channel A's parameters, long press the menu button to enter setting interface during the A's parameters are displayed. Then, short press the menu button to switch to the next setting. To set channel B's parameters, long press the menu button to enter setting interface during the B's parameters are displayed. A B RCVR-A ON CH: 01 VOL: 25 514.
Transmitter ① Insert the omnidirectional lavalier microphone into the transmitter’s MIC port. ② Turn on the transmitter to set the relevant parameters. ③ Clip the transmitter onto the belt or put it into your pocket. Receiver ① Connect the 1/4” cold shoe onto the receiver, and install them on the camera or shooting equipment. ② Insert one end of the 3.5mm cable into the receiver’s OUTPUT port and the other end into camera’s MIC port. ③ Turn on the receiver to set relevant parameters.
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Inapplicable Cases The guarantee and service offered by this document are not applicable in the following cases: ①. The product or accessory has expired its warranty period; ②. Breakage or damage caused by inappropriate usage, maintenance or preservation, such as improper packing, improper usage, improper plugging in/out external equipment, falling off or squeezing by external force, contacting or exposing to the improper temperature, solvent, acid, base, flooding and damp environments, etc; ③.