Instruction Manual

- 19 - - 20 -
Troubleshooting
• If icon appeared and blinking and icon is also appeared on the display:
It might be the fan failure. Please contact with customer service.
• If icon appeared and blinking and icon is also appeared on the display:
(1) If the icons are displayed in cool-light state (just being turned on or for a little
while), it might be probe failure. Please contact with customer service.
(2) If the icons are displayed in hot-light state (being turned on for a long while), it
might be caused by long-time usage and over temperature. Please turn off the
light and turn it on after the light is cooled down.
Maintenance
This product, except consumables e.g. adapter and power cable, is supported
with a one-year warranty.
Maintenance of the flash must be performed by our authorized maintenance
department which can provide original accessories.
Unauthorized service will void the warranty.
If the product had failures or was wetted, do not use it until it is repaired by
professionals.
If there is anything abnormal during LED light’s working, please turn it off
immediately and identify the reasons.
Changes made to the specifications or designs may not be reflected in this
manual.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

QCPASS
This equipment complies with radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.