User's Manual

Battery Level Indication
on the OLED panel
3 grids
2 grids
1 grid
Blank grid
Blinking
Meaning
Full battery
Medium battery
Low battery
Lower battery, please recharge it.
The battery level is going to be used out immediately. And the flash will
auto power off in 1 minute.
Note: Please recharge the battery as soon as possible (within 10 days).
Then, the battery can be used or be placed for long period.
Lithium Battery
● No over 24 hours' continuous charging.
2. It is reliably safe. The inner circuit is against overcharge, overdischarge, overcurrent,
and short circuit.
Features
3. Take only 3.5 hours to fully charge the battery by using the standard battery charger.
● Do not short circuit.
● Do not expose to rain or immerse into water. This battery is not water proof.
Cautions:
1. This flash unit uses Li-ion polymer battery which has long runtime. The Available
charge-and-discharge times are 500.
● Keep out of reach of children.
● Store in dry, cool, ventilated places.
● Do not put aside or into fire.
● Dead batteries should be diaposed according to local reglations.
● Long time not to use, please charge it to 60% and then placed.
● It is recommended to fully recharge the battery every three months.
Power Management
< > to wake it up in off state. When the unlock icon appears, turn the select dial to
operate.
ON/OFF Power Switch controls the on/off of the flash unit, turn off the power pack if the
flash unit will not be used for an extended period. The product design of power supply
with automatic power off feature, When unattended operation for a long time (approx.
30/60/90 minutes ), the flash will automatically power off. Please press the power switch
Disabling Auto Power Off function is recommended when the flash is
used off camera. (C.Fn - STBY)
C.Fn
Modeling Lamp
1. Power on/off the modeling lamp:
short press the < > to control the
modeling lamp's on or off.
2. Setting: long press the < > to
enter modeling lamp setting.
2.1 Brightness setting: Turn the select
dial to change the brightness value
from 1 to 10 level.
Wireless Flash Mode
AD100Pro can only be set as receiver
unit (receiver end). Press the menu
button to enter C.Fn-WL to switch the
radio transmission function.
Wireless Mode
OFF
ON
Flash Mode
M / Multi
TTL / M / Multi
21
CH
M
A
1/256 + 0.6
85mm
S2
A
1/256 + 0.6
85mm
S2
- 31 - - 32 -
Battery Level Indication
Make sure the battery pack is securely loaded in the flash. Check the battery level
indication on the OLED panel to see the remaining battery level.
2. Insert the battery into the compartment with a
click sound. The battery is successfully installed
when the battery release button slides to the right
automatically.
If you heard a "click" but the battery release button
only slid to the middle and stopped, the battery is
not installed correctly. Please push the battery again
until a "click" occurs and the battery release button
slides to the right automatically.
Note: Please catch the battery with your hands
when you detaching it, in case of affecting the
battery's service life due to falling.
1. Aim the battery into the battery compartment of
the flash.
Push the battery release button to the left until the
battery pops out.
Detachment
installation
Battery Installation and Detachment