User Manual
AD200Pro adopts Godox 2.4G wireless X system, which has good compatibility with other products of our
company. As a slave unit, AD200Pro is automatically compatible with Canon/ Nikon/ Sony TTL system according to
the master unit. Nikon cameras (use X1T-N), Canon cameras (use X1T-C) and Sony cameras (use X1T-S) can use
one or more AD200Pro-TTL flashes simultaneously.
Wireless Flash Shooting
1. Wireless Settings
Press the wireless selection button to switch wireless function ON/ OFF.
Turn the wireless function on, the < > icon will be displayed on the AV panel.
When using the FT-16 remote control or others trigger, please turn off the wireless function.
2. Setting the Communication Channel
If there are other wireless flash systems nearby, you can change the channel IDs to prevent signal interference. The
channel IDs of the master unit and the slave unit(s) must be set to the same.
Long press the <GR/CH>
1 Button for 2 seconds, so that
the icon will be displayed on
the AV panel.
Turn the Select Dial to choose
2 a channel ID from 1 to 32.
Press the <SET> button to
3 confirm.
3. Setting the Communication Group
Short press the < GR/CH > button to choose group ID from A to E.
Positioning and Operation Range
(Example of wireless flash shooting)
● Autoflash Shooting with One Slave Unit
● Use the supplied stand to position the slave unit.
● Before shooting, perform a test flash and test shooting.
● The transmission distance might be shorter depending on the conditions such as positioning of slave
units, the surrounding environment and whether conditions.
● With a lot of wireless signal interference conditions, if you miss flash, please change the wireless
communication channel.
Transmission distance is about 100m
Wireless Multiple Flash Shooting
You can divide the slave units into two or three groups and perform TTL autoflash while changing the flash ratio
(factor). In addition, you can set and shoot with a different flash mode for each firing group, for up to 5 groups.
● Auto Shooting with Two Slave Groups
● Auto Shooting with Three Slave Groups
When using the AD200Pro and Godox X1 series trigger together，the X1 can control the flash function such as:
● Flash Mode: TTL, M, Multi ● Sync Mode: First-curtain sync, second-curtain sync and High-speed sync
● Control the power level ● Modeling Lamp turn on or off ● Beeper turn on or off
- 37 - - 38 -
A
B
A
B
C
t0 1
sec
min
Hz
MK
12
c
t0 1
sec
min
Hz
MK
12
c
sec
min
Hz
c
t0 1
sec
min
Hz
MK
12
c
t0 1
sec
min
Hz
MK
12
c
4. Wireless ID Settings
Press the MENU button to enter C.Fn to
choose OFF or any figure from 01-99.
Note: This can only be used when the master
unit possesses the wireless ID function.