User's Manual

Other Operation Tips:
● Pressing the ON/OFF button on the remote control can turn on/off all the LED groups.
● Pressing the “SET” button on the remote control for 2 seconds can turn on/off the
current LED group.
● The remote control will auto power off after four hours of idle operation.
Tips of Using Remote Control:
(1)When using the Daylight Version LED1000D II, please set the color
temperature of the remote control as 5600K constantly;
(2)Please remove the battery if the light will not be used for an extended period
of time.
5. Replacing A Color Filter
● Pinch the edge of the color filter (02) and pull
it out upwardly.
● Insert a new color filter in and push it
downwardly. Then the color filter is securely
in position.
What’s in the Box of LED1000II?
Included Item
LED Video Light
Remote Control
Power Adapter
Power Cord
Diffusion Filter
Yellow Filter
Blue Filter
NO.
1
2
3
4
5
6
7
LED1000D II
1 PC
1 PC
1 PC
1 PC
1 PC
1 PC
1 PC
LED 1000Bi II
1 PC
1 PC
1 PC
1 PC
1 PC
NO
NO
LED Video Light
Remote Control
Power Adapter
Power Cord
DMX Mode
1. Choose DMX Mode
● In the initial state, hold down the RUN/STOP
button and power the light on to enter DMX mode,
and the brightness value and color temperature
value will be displayed on the LCD panel.
● In LED general mode, long press the RUN/STOP
button to enter DMX mode. In this way, the
brightness value and color temperature value won’t
be displayed on the LCD panel.
2. Set DMX Channel
● Press the SET button and the DMX channel will
be blinking. Turn the select dial to set DMX from
1 to 512.
3. Connect to Console
● Choose DMX port according to the model to
be controlled. Each light will occupy two DMX
channels and the light brightness or color temperature can be adjusted.
Note: In DMX mode, the color temperature and light brightness can only be
controlled by the console.