User Manual

Tube Replacement
Shut down the power and remove the power cord before replacing the flash tube. Wear
insulated gloves to loosen the iron wire on the tube, keep a balanced hold on the two
feet of the flash tube and pull out the old tube gently. Take down the feet casing from the
old tube and put it on the new one. Hold two feet of the new tube, and target directly
towards the two copper outlets, then push them slightly in. Twine the iron wire on the
stainless steel sheet to fix the flash tube.
MAINTENANCE
Avoid sudden impacts and the lamp should be dedusted regularly.
Maintenance of the flash must be performed by our authorized maintenance department
which can provide original accessories. The flash-tube and the modeling lamp are user-
replaceable. Replacement tubes and lamps can be obtained from the manufacturer.
If the product had failures or was wetted, do not use it until it is repaired by professional.
Shut down the device immediately when it works abnormally and find out the reason.
Changes made to the specifications or designs may not be reflected in this manual.
This product, except consumables e.g. flash tube and modeling lamp, is supported with
a one-year warranty.
Unauthorized service will void the warranty.
Disconnect the power when cleaning the flash or when changing the flashtube /
modeling lamp.
It is normal for the lamp to be warm when in use. Avoid continuous flashes if
unnecessary.
TECHNICAL DATA
Model
Max Power (Ws)
Guide Number(m ISO 100)
(use with highly effective
reflector)
Color Temperature
Operating Voltage
Power Output Control
Modeling Lamp (W)
Modeling Lamp Level
Recycle Time
Triggering Method
Flash Duration
Parameters output from
the sync cord jack
Parameters output from
the USB port
Fuse
Dimension
Net Weight
MS300
300Ws
58
MS200
200Ws
53
5600±200k
AC110V-120V~60Hz//AC220-240V(50Hz)
5.0~10.0(1/32~1/1)
150W
5%~100%
220V(0.1~1.3s)/110V(0.1~1.8s)
Sync cord, Test button, Slave triggering, Wireless control port
1/2000~1/800s
5V
5V/200mA (only for Godox receiver)
F8AL 250V
Flash diameterΦ12.6cm,
height of flash with handle 12.7cm
length of flash with lamp cover 28.3cm
Approx. 2.6kg
- 17 - - 18 -
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Increase the separation between the equipment and receiver.
-Consult the dealer or an experienced radio/TV technician for help.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Reorient or relocate the receiving antenna.
FCC