User's Manual

GRP/CH/RF Setting: Long press the menu button to enter the setting
interface. Then, short press the menu button to switch the next
setting.
GRP Group setting: Choose GRP and press +/- to choose A or B group.
CH Channel setting: Choose CH and press +/- to set channel from 01 to 48.
RF Power setting: Choose RF power to switch H/L power.
Display brightness setting: short press +/- button until OLED light is
displayed on the panel. Then, long press the menu button to choose
the corresponding brightness level of OLED light. Short press +/-
button to choose brightness from 1 to 8 levels.
Software version: short press +/- button until Version is displayed,
which means the version of software.
Backlighting time: Short press +/- until Back Light is displayed on the
LCD panel. Then,long press the menu button and the backlighting
time will be blinking. Short press the +/-button to choose backlighting
time: ON means lighting and OFF means off. Delay10S/30S/60S.
Restore factory settings: short press the +/- button until Restore
Default is displayed. Then, long press the menu button to restore
factory settings.
- 17 - - 18 -
-
-
-
•
•
•
•
•
The setting methods of power on&off/GRP/CH is the same
as transmitter. Set the receiver’ s group and channel to the
same as the transmitter’s to record sound.
Display brightness setting: short press +/- button until
OLED light is displayed on the panel. Then, long press the
menu button and the corresponding brightness value of
OLED light will be blinking. Short press +/- button to
choose brightness from 1 to 8 levels.
Output mode: there are Stereo mode and Mono mode.
Receiver Setting
Short press +/- button to enteroutput mode. Then, long pressthe
menubutton to switch the two channels. When in Monochannel
output, the sound of left channel and right channel will be output
simultaneously. When in Stereo channel output, the sound of left
channel(A group) and right channel(B group) will be output inde-
pendently. The default channel of this system is Mono channel.
Software version: short press +/- button until Version is displayed,
which means the version of software.
Backlighting time: Short press +/- until Back Light is displayed on
the LCD panel. Then, long press the menu button and the backlight-
ing time will be blinking. Short press the +/- button to choose back-
lighting time: ON means lighting and OFF means off.
Delay10S/30S/60S.
Restore factory settings: short press the +/- button until Restore
Default is displayed. Then, long press the menu button to restore
factory settings.
•
•
•
•
•
•
OUTPUT: To connect with external audio signal output.
PHONES: To connect with earphone cable.
Receiver Port
LINE IN: To connect with external audio signal input.
MIC: To connect with lavalier microphone.
Transmitter Port
UWM
LINE IN MIC