User Manual

Functions
Custom
Functions No.
Settings and Description
PC sync socket connects with camera
PC sync socket connects with flash
Multi flash OFF
Multi flash ON
The minimum power output in M/Multi mode is 1/128
The minimum power output in M/Multi mode is 1/256
ON
OFF
A/B/C
A/B/C/D/E
ON
OFF
Setting Signs
in
ou
--
on
1/128
1/256
--
on
03
05
--
on
PC sync socket
connects with camera
/camera flash
Minimum power
output in M/Multi
mode
C.Fn-03
C.Fn-04
C.Fn-05
C.Fn-06
C.Fn-08
Only send after the setting values have been changed.
Forcibly send the setting values before firing even though
the values has not been changed.
--
on
C.Fn-09
C.Fn-07
- 36 -
- 35 -
Setting the Transmitter
C.Fn-10
--
on
The transmitter is in the master mode, which can set the
receiver's mode and output on the transmitter end.
Open the APP mode and the transmitter can only trigger
flashes. Only channel and custom settings can be
adjusted and the LCD panel will display APP.
Number of groups
Beep
Send setting values
forcibly
APP mode
C.Fn-11
Setting the specific
cameras and flashes
00
01
02
The general FUJIFILM cameras
The cameras that use between-the-lens-shutters e.g.X100F,
X100T, etc. Choose this option and set all groups to M mode
can reach high-speed sync within 1/1250s.
Choose this option and set all groups to M mode can
solve the problem that the TT600 and V850II cannot
achieve high-speed sync flash when triggered by X1T-F.
Multi Flash
ON/OFF
Af assist
Setting the Transmitter
Setting the Camera
To trigger X1T-F, please set camera's flash mode to TTL flash.
EXIT
TTL-LOCK MODE
MASTER SETTING
CH SETTING
LED LIGHT SETTING
RED EYE REMOVAL
FLASH SETTING
FLASH FUNCTION SETTING
FUJIFilm Camera side flash mode setting:
1. Press the <CH/OK> Button for 2 seconds or longer until <Fn> is displayed.
2. Select the custom function No.
* Turn the Select Dial to choose the Custom Function No.
3. Change the Setting.
* Press the <GR> Button until the custom function No. blinks.
* Turn the Select Dial to set the desired number. Pressing <GR> button will confirm
the settings.
* Press <MODE> button to exit the C.Fn settings.
Double-click the CH Button to turn on/off the modeling lamp of the receive end.
Press the TEST Button to turn on the flash trigger. When the Status Indicator Lamp blinks two
times, it means the effective remote distance is below 30 meters, thus the transmitter and receiver
can communicate normally no matter how near they are.