User Manual

Modeling Lamp Settings
1. Long press the <MENU> button for 2 seconds to
control the ON/OFF of the modeling lamp.
Setting the Flash Trigger
1/4
ZOOM
SHUTTER
V0.2
BLUE.T.
BEEP
OFF
ON
Shutter Sync Settings
Press the <MENU> button to enter C.Fn BEEP and
press the <SET> button. Choose ON to turn on the
BEEP while OFF to turn off it. Press the <MENU>
button again to back to the main menu.
Buzz Settings
Setting the Flash Trigger
ZOOM Value Settings
Short press the <MENU> button to enter the ZOOM
menu. Short press the <SET> button and turn the
select dial, and the ZOOM value will change from
AUTO/24 to 200. Choose the desired value and back
to the main menu.
Note: The flash’s ZOOM should be set to Auto (A) mode before
responding.
SHUTTER
V0.2
1/4
BLUE.T.
BEEP
ZOOM
24
SCAN
V0.2
2/4
CH
ID
IN
OUT
PC SYNC
1. Press the <MENU> button to enter C.Fn SYNC
and press the <SET> button to choose IN or OUT.
Press the <MENU> button again to back to the
main menu.
1.1 When choosing IN, this sync socket will
enable X2T-F to trigger flash.
1.2 When choosing OUT, this sync socket will
send trigger signals to trigger other remote
control and flash.
Sync Socket Settings
- 34 -- 33 -
1. High-speed sync: setting the SYNC in flash
function setting to FP on FUJIFILM camera until
is displayed on the flash trigger’s LCD panel.
Then, setting the camera shutter.
2. Second-curtain sync: setting the SYNC in flash
function setting to REAR on FUJIFILM camera
until is displayed on the flash trigger’s LCD
panel. Then, setting the camera shutter.
C
CH 01
M
1/128
A
B