User's Manual

5. As a Wireless Shutter Release Trigger
Operation method:
5.1 Turn off the camera. Take a camera remote
cable and insert one end into the camera’s
shutter socket and the other end to the
shutter release port of X1R-S to connect.
Power on the camera and the receiver.
5.2 Short press the <MENU> button to set
channel, group, mode and parameters
(refers to the contents of “Setting the Flash
Trigger”).
5.3 Press the receiver’s <CH> button to set the
same channel to the flash trigger, and press
the <Gr> button to set the same group to the
flash trigger.
5.4 Half press the button to focus and full
press the <TEST> button to shoot. Release
the button until the status lamp turns to red.
Using the Flash Trigger
Using the Flash Trigger
6. As a Flash Trigger with 3.5mm Sync Cord Jack
Operation method:
6.1 The connection method please refers to the
contents of “As a Wireless Studio Flash Trigger”
and “As a Wireless Shutter Release”.
6.2 Set the transmitter end’s sync cord jack as an
output port. Operation: press the <MENU>
button on the transmitter end to enter C.Fn
settings. Then, set PC SYNC to OUT mode.
6.3 Press the shutter normally and the flashes will
be controlled by sync cord jack's signal.
7. Connect to Smartphone through Bluetooth
Using method:
7.1 Short press the <MENU> Button to enter
BLUE.T. to open the Bluetooth. The Bluetooth ID
will displayed under the ON.
7.2 Search“Godox Photo”in iPhone’s APP Store
and download the APP. Or install the APP by
scanning the QR Code with your smartphone.
7.3 Open the APP and choose .
7.4 Connect the transmitter to the responded
Bluetooth ID and enter the password to
match(the initial password is “000000”).
SYNC
V0.2
1/4
BLUE.T.
BEEP
ZOOM
OFF
ON
GDBHA7BC
"GodoxPhoto"
- 42 -- 41 -